HDAF389A13DC Datasheet, PDF (7/9 Pages) Shoulder Electronics Limited. – SAW FILTER

SAW FILTER
HDAF389A13Dc SIP5Dc
Solder ability
The specimen shall be passed through the reflow
furnace with the condition shown in the above
profile for 1 time.
The specimen shall be stored at standard
atmospheric conditions for 1h, after which the
measurement shall be made. Test board shall be
1.6 mm thick. Base material shall be glass fabric
base epoxy resin.
Immerse the pins melt solder at 260℃+5/-0℃
for 5 sec.
More then 95% of
total area of the
pins should be
covered with solder
3.4Mechanical Test
Items
Conditions
Vibration
600-3300rpm amplitude 1.5mm
3 directions 2 H each
Drop
On maple plate from 1m high 3 times
Lead pull
Lead bend
Pull with 1kg force for 30 seconds
90^o bending with 500g weigh 2 times
Specifications
There shall be no
damage.
3.5Voltage Discharge Test
Item
Condition
Surge
Between any two electrode
Specifications
There shall be no
damage
www.shoulder.cn Tel:[phone] Fax:[phone] E-mail:[e-mail]
Page 7 of 9