|
GP1A51HRJ00F Datasheet, PDF (9/12 Pages) Sharp Electrionic Components – Gap : 3mm, Slit : 0.5mm OPIC Output Case package Transmissive Photointerrupter | |||
|
◁ |
â Manufacturing Guidelines
â Soldering Method
Flow Soldering:
Soldering should be completed below 260ËC and within 5 s.
Please take care not to let any external force exert on lead pins.
Please don't do soldering with preheating, and please don't do soldering by reï¬ow.
GP1A51HRJ00F
Hand soldering
Hand soldering should be completed within 3 s when the point of solder iron is below 350ÌC.
Please solder within one time.
Please don't touch the terminals directly by soldering iron.
Soldered product shall treat at normal temperature.
Other notice
Please test the soldering method in actual condition and make sure the soldering works fine, since the
impact on the junction between the device and PCB varies depending on the cooling and soldering
conditions.
Flux
Some ï¬ux, which is used in soldering, may crack the package due to synergistic effect of alcohol in ï¬ux and
the rise in temperature by heat in soldering. Therefore, in using ï¬ux, please make sure that it does not have
any inï¬uence on appearance and reliability of the photointerrupter.
Sheet No.: D3-A03601EN
9
|
▷ |