GP2A200LCS0F Datasheet, PDF (7/10 Pages) Sharp Electrionic Components – Detecting Distance : 2 to 22mm OPIC Output, Refl ective Photointerrupter with Connector

GP2A200LCS0F Series
■ Design Considerations
● Design guide
1) V_O terminal : Open collector output
This product operates the light emitter by pulse drive. Please supply the stable supply voltage in order to
prevent error operation by pulse current.
Please use this device after connecting a capacitor between V_O and GND for prevention of line noise.
2) Prevention of detection error
Please be careful that you need to keep the direct inverter light away from the photo detecting surface
since the device will not operate correctly in such case.
In addition, we recommend to make sure the operation test in the actual application.
3) Plugging in/out
The connector should be plugged in/out at normal temperature.
This product is not designed against irradiation and incorporates non-coherent IRED.
● Parts
This product is assembled using the below parts.
• Photodetector (Q'ty : 1) [Using a silicon photodiode as light detecting portion, and a bipolar IC as signal processing circuit]
Category
Maximum Sensitivity
wavelength (nm)
Sensitivity
wavelength (nm)
Response time (μs)
Phototransistor
900
700 to 1 200
400
• Photo emitter (Q'ty : 1)
Category
Infrared emitting diode
(non-coherent)
Material
Gallium arsenide (GaAs)
Maximum light emitting
wavelength (nm)
950
I/O Frequency (MHz)
0.3
• Material
GP2A200LCS0F
GP2A200LCSCF
GP2A210LCSJF^∗
GP2A240LCS0F
Case
Black polyphernylene
Sulfide resin (UL94 V-0)
Lens
Polycarbonate resin
(UL94 V-2)
Bottom cover
Polycarbonate resin (Gray)
(UL94 V-2)
Polycarbonate resin (Navy Blue)
(UL94 V-2)
∗The IR-90 filter (Fuji Photo Film Co., Ltd.) is inserted between case and detector side lens.
• Others
Laser generator is not used.
Sheet No.: D3-A05101EN
7