LQ0DDB0004 Datasheet, PDF (6/8 Pages) Sharp Electrionic Components – DEVICE SPECIFICATION FOR LAMP UNIT

SHARP
LCY99050- 5
(8) Procedure to exchange Lamp unit
Lamps for the LCD module can be worn out, so please replace them to new lamps when needed in
accordance with the following. Please make sure that power is off before you replace them to
prevent you from getting an electrical shock. Please insert the lamp with care while replacing. Please
be careful for any dust goes in.
0 Remove 2 screws which holds the Lamp unit. (refer to Fig. 2)
@ Slide the Lamp unit to the “B” direction.
0 Remove the Lamp unit. (“C’direction)
@ Replace the new Lamp unit to the “ D “direction and slide the unite to the “E” direction.
(refer to Fig.3)
@ Tighten the 2 screws to lix the Lamp unit along the screw gap of. hole. The screw torque
should be maximum 1.6kgf * cm. If you tighten the screw over 1.6kgf.cm, the screw should
be destroyed. Please be careful.
@ Please insert the lamp with care while replacing. Please be careful for any dust that goes in.
Please make sure that the lamp unit is in all the way.
w
Fig. 2. Procedure to exchange Lamp unit.