GP1FAV50RK0F Datasheet, PDF (6/9 Pages) Sharp Electrionic Components – Fiber Optic Receiver Square connector With mounting hole Protection cap type

Fig. 4 Pulse Response and Jitter
Fiber optic cable
Standard transmitter
Vin
VCC
GND
5V
CH1
Input
CH2
Input signal
6.6 Mb/s bi-phase PRBS signal
GP1FAV50RK0F
GP1FAV50RK0F Device under test
VCC
GND
VCC
Rso
Vout
Rsi
Tektronix 7834 or 7934 type Oscilloscope
Trigger ; CH1
Mode ; Storage mode
Sweep ; AUTO/NORM
Fig. 5 Input Signal (6.6 Mb/s Bi-phase PRBS Signal)
Input signal
GP1FAV50RK0F output
50%
50%
Δt_j
Δt_j
Notes
(1) The fiber coupling light output set at –14.5 dBm or –24.0 dBm.
(2) Rsi, Rso: Standard load resistor (Rsi: 3.3 kΩ, Rso: 2.2 kΩ)
(3) Set the oscilloscope to the storage mode and write time to 3 seconds.
Do not allow the brightness to be increased too much. The waveform would be distorted.
(4) VCC = 5.0 V (State of operating)
(5) The probe for the oscilloscope must be more than 1 MΩ and less than 10 pF.
6
Sheet No.: E2-A01201EN