GP1UM261XKVF Datasheet, PDF (3/6 Pages) Sharp Electrionic Components – Compact IR Detecting Unit for Remote Control

Internal Block Diagram
GP1UM26XK0VF/GP1UM27XK0VF Series
GP1UM28XK0VF/GP1UM28YK0VF Series
R_L
Limiter
B.P.F. Demodulator Integrator Comparator
V_OUT
V_CC
GND
Absolute Maximum Ratings
(Ta=25
Parameter
Symbol Rating Unit
Supply voltage
V _CC
0 to +6.0 V
*1 _{Operating temperature Topr}
10 to 70
Storage temperature
T_stg
20 to 70
*2 _{Soldering temperature Tsol}
260
*1 No dew condensation is allowed
*2 For 5s (At mounting on PCB with thickness of 1.6mm)
Recommended Operating Conditions
Parameter
Symbol Operating conditions Unit
Supply voltage
V _CC
4.5 to 5.5
V
Electro-optical Characteristics
(Ta=25, V CC=5V)
Parameter
Symbol
Conditions
MIN. TYP.
MAX. Unit
Dissipation current
High level output voltage
Low level output voltage
High level pulse width
Low level pulse width
B.P.F. center frequency
Output pull-up resistance
I CC
No input light
0.5 0.6(0.65)^*4 mA
V OH
*3
VCC-0.5
V
V OL
*3 _IOL=1.6mA
0.45 V
T1
*3
600
1200 s
T2
*3
400
1000 s
f0
*5
kHz
RL
70
100
130 k
*3 The burst wave as shown in the following figure shall be transmitted by the transmitter shown in Fig. 1
The carrier frequency of the transmitter, however, shall be same as *5, and measurement shall be from just after starting the transmission until 50 pulse
*4 In case of B.P.F. center frequency f0 :56.8kHz model
*5 The B.P.F. center frequency f0 varies with model, as shown in Model Line-up
B urs t wave
s
1000s
f0=( * 5)
Duty 50%
Sheet No.: OP06008
3