GP1U58Y Datasheet, PDF (3/4 Pages) Sharp Electrionic Components – IR Detecting Unit For Remote Control

GP1U58Y Series
s Performance
Using the transmitter shown in Fig. 1, the output signal of the light detecting unit is good enough
to meet the following items in the standard optical system in Fig. 2.
( 1) Linear reception distance characteristics
When L= 0.2 to 8m, Ee<10 lx and φ = 0˚ in Fig. 2, the output signal shall meet the electrical
characteristcs in the attached list.
( 2) Sensitivity angle reception distance characteristics
When L= 0.2 to 6m, Ee< 10 lx and φ <= 30˚ in Fig. 2, the output signal shall meet the electrical
characteristics in the attached list.
( 3) Anti outer peripheral light reception distance characteristics
When L= 0.2 to 4m, Ee<=300 lx and φ = 0˚ in Fig. 2, the output signal shall meet the electrical
characteristics in the attached list.
20cm
10k Ω
+ 5V
Transmitter (GL521 used )
Duty 50 %
Center frequency (fo)
depends on the attached
model list.
Fig. 1. Transmitter
Vout
Oscilloscope
In the above figure, the transmitter should be set so that the output V out can be 40mV PP .
However, the PD49PI to be used here should be of the short-circuit current ISC = 2.6 µ A at EV=
100 lx.
(E_V is an illuminance by CIE standard light source A ( tungsten lamp ) .)
Transmitter
Reception distance : L
Light detector face
illuminance : Ee
φ
φ
Vout
(φ indicates horizontal and
vertical directions. )
Fig. 2. Standard optical system