GP2W0001YP Datasheet, PDF (13/15 Pages) Sharp Electrionic Components – IrDA Data Sheet 115 kbps Transceiver

115 kbps Transceiver
GP2W0001YP
TAPING MOISTURE-PROOF PACKING
Packaging Specifications
Table 2. Packaging Material
NAME
Aluminum laminate bag
Label
Desiccant
Outer case
Pads
MATERIAL
Aluminum polyethylene
Paper
Paper
Paper
Packaging Method
• Seal the aluminum laminated bag containing the
tape reel (2,000 pieces per reel) and desiccant.
• Fill out necessary information on the label and paste
it on the aluminum laminate bag.
• Pack four aluminum laminated bags (containing one
reel each) into the designated outer case, where
paper pads are placed on the bottom and top of the
outer case, as well as between each layer of the alu-
minum laminated bags. Minimum order/shipment
quantity should be one laminated bag.
• The outer case should then be sealed with packing
tape, indicating the model name, quantity, and out-
going inspection data on the case. Total of 8,000
pieces per carton.
Table 3. Packaging Method Specifications
PACKAGE
SHAPE
Tape reel
(φ 330 mm)
PRODUCT
1 model
QUANTITY
2,000
pieces
per reel
SACK
QUANTITY
1 reel per
moisture-proof
laminated bag
Storage and Treatment After Unsealing
• Storage conditions: The product should be stored
with these conditions:
– Storage temperature: 10°C to 30°C
– Humidity: below 60% RH
• Treatment after opening:
– After unsealing, devices should be mounted un-
der the temperature condition of 10°C to 30°C, at
the humidity conditions of below 60% RH, within
two days.
– In case long term storage is needed, devices
should either be stored in dry box or re-sealed in
a moisture-proof bag with desiccant and kept in
an environment where the temperature is 10°C to
30°C, at the humidity condition of below 60% RH.
Devices must be mounted within two weeks.
• Baking before mounting:
– In the event that the devices are not maintained
in the recommended storage conditions or the
enclosed desiccant indicator has turned pink,
baking must be done before devices are mount-
ed. Please also note that baking should only be
done once.
– Recommended condition: 100°C, 12 to 24 hours.
– Baking will not be properly done with the devices
in their shipping package. To complete the baking
properly, devices should either be temporarily
mounted to PCB with adhesive, or placed in a
metal tray. The temporary mounting should be
done using adhesive, not by soldering.
IrDA Data Sheet
13