S216SE2 Datasheet, PDF (1/14 Pages) Sharp Electrionic Components – Reinforced Insulation Type Zero Cross type SIP 4pin Triac output SSR

S216SE2 Series
S216SE2 Series
∗_{Non-zero cross type is also available. (S216SE1 Series)}
IT(rms)≤16A,
Reinforced Insulation Type
Zero Cross type
SIP 4pin
Triac output SSR
■ Description
S216SE2 Series reinforced insulation type Solid
State Relays (SSR) are an integration of an infrared
emitting diode (IRED), a Phototriac Detector and a
main output Triac. These devices are ideally suited for
controlling high voltage AC loads with solid state
reliability while providing 3.0kV isolation (V_iso(rms))
from input to output.
■ Features
1. Output current, IT(rms)≤16.0A
2. Zero crossing functionary (VOX : MAX. 35V)
3. 4 pin SIP package
4. High repetitive peak off-state voltage (VDRM : 600V)
5. Reinforced insulation type (MIN. 0.4mm internal
separation)
6. High isolation voltage between input and output
(Viso(rms) : 3.0kV)
7. Lead-free terminal components are also available
(see Model Line-up section in this datasheet)
8. Screw hole for heat sink
■ Agency approvals/Compliance
1. Approved by TÜV EN60950 (reinforced insulation),
file No. R9051479 (as models No. S216SE2)
2. Package resin : UL flammability grade (94V-0)
■ Applications
1. Isolated interface between high voltage AC devices
and lower voltage DC control circuitry.
2. Switching motors, fans, heaters, solenoids, and
valves.
3. Power control in applications such as lighting and
temperature control equipment.
Notice The content of data sheet is subject to change without prior notice.
In the absence of confirmation by device specification sheets, SHARP takes no responsibility for any defects that may occur in equipment using any SHARP
devices shown in catalogs, data books, etc. Contact SHARP in order to obtain the latest device specification sheets before using any SHARP device.
Sheet No.:D4-A03501EN
1
Date Apr. 28. 2004
© SHARP Corporation