S16MD01 Datasheet, PDF (1/4 Pages) Sharp Electrionic Components – 8-Pin DIP Type SSR for Low Power Control

S16MD01/S16MD02
S26MD01/S26MD02
S16MD01/S16MD02/S26MD01/S26MD02
8-Pin DIP Type SSR for Low
Power Control
s Features
1. Compact 8-pin dual-in-line package type
2. RMS ON-state current IT : 0.6Arms
3. Built-in zero-cross circuit
(S16MD02 / S26MD02 )
4. High repetitive peak OFF-state voltage
S16MD01 / S16MD02 VDRM : MIN. 400V
S26MD01 / S26MD02 VDRM : MIN. 600V
5. Isolation voltage between input and output
( V_iso : 4,000Vrms )
6. Recognized by UL, file No. E94758
7. Approved by CSA No. LR63705
s Applications
1. Oil fan heaters
2. Microwave ovens
3. Refrigerators
s Model Line-ups
No built-in zero-
cross circuit
Built-in zero-
cross circuit
For 100V lines
S16MD01
S16MD02
For 200V lines
S26MD01
S26MD02
s Outline Dimensions
(Unit : mm )
Internal connection Diagram
8
65
g
Zero-cross
circuit
1 23 4
2.54 ^{± 0.25}
1 Cathode
2 Anode
3 Cathode
4 Cathode
5G
6 T₁
8 T₂
Anode
mark
8
65
A
12 3
9.66 ^{± 0.5}
4
1.2
±
0.3
A (Model No.)
S16MD01
S16MD02
S26MD01
S26MD02
7.62 ^{± 0.3}
0.5 ^{± 0.1}
0.26 ^{± 0.1}
θ : 0 to 13˚ _θ
g Zero-cross circuit for S16MD02 and S26MD02
Terminal 1 , 3 and 4 are common ones of cathode.
To radiate the heat, solder all of the lead pins
on the pattern of PWB.
s Absolute Maximum Ratings
Parameter
Input
Forward current
Reverse voltage
RMS ON-state current
Output
*1 _{Peak one cycle surge current}
Repetitive peak OFF-
state voltage
S16MD01 / S16MD02
S26MD01 / S26MD02
*2 _{Isolation voltage}
Operating temperature
Storage temperature
*3_{Soldering temperature}
*1 50Hz sine wave
*2 AC for 1 minute, 40 to 60% RH, f = 60Hz
*3 For 10 seconds
Symbol
IF
VR
IT
I surge
V DRM
V iso
T opr
T stg
T sol
(Ta = 25 ˚C)
Rating
Unit
50
mA
6
V
0.6
A rms
6
A
400
V
600
V
4 000
V rms
- 25 to + 80
˚C
- 40 to + 125
˚C
260
˚C
“ In the absence of confirmation by device specification sheets, SHARP takes no responsibility for any defects that occur in equipment using any of SHARP's devices, shown in catalogs,
data books, etc. Contact SHARP in order to obtain the latest version of the device specification sheets before using any SHARP's device.”