S108T01 Datasheet, PDF (1/5 Pages) Sharp Electrionic Components – Low Profile Type Solid State Relays

S108T01/S108T02/S208T01/S208T02
S108T01/S108T02
S208T01/S208T02
s Features
1. Low profile type (height : 16mm)
2. Built-in zero-cross circuit (S108T02/S208T02)
3. RMS ON-state current IT : MAX. 8Arms
4. Approved by TÜV, No. R9750791 (S208TY1/S208TY2)
Input-Output : Basic Insulation
s Applications
1. Programmable controllers
2. Air conditioners
3. Copiers
4. Automatic vending machines
s Model line-ups
For 100V lines
No zero-cross circuit
Built-in zero-cross circuit
S108T01
S108T02
For 200V lines
S208T01
S208T02
s Absolute Maximum Ratings
(Ta=25°C)
Parameter
Symbol Rating Unit
Forward current
IF
50
mA
Reverse voltage
VR
6
V
RMS ON-state current IT
*1 ₈
Arms
*2 _{Peak one cycle surge current Isurge}
80
A
S108T01
Repetitive
400
S108T02
peak OFF-
state voltage ^S208T01
VDRM
600
V
S208T02
S108T01
Non-repetitive
S108T02
peak OFF-
state voltage ^S208T01
S208T02
Critical rate of rise of ON-state current
Operating frequency
Operating temperature
Storage temperature
*3 _{Isolation voltage}
*4 _{Soldering temperature}
VDSM
dIT/dt
f
Topr
Tstg
Viso
Tsol
400
600
50
45 to 65
−25 to +100
−30 to +125
3.0
260
V
A/µs
Hz
°C
°C
kVrms
°C
*1 Refer to Fig.2, Fig.3
*2 60Hz sine wave, start at Tj=25°C
*3 Isolation voltage measuring method
(1) Dielectric withstand voltage tester with zero cross circuit shall be used.
(2) The applied voltage waveform shall be sine wave.
(3) Voltage shall be applied between input and output.
(Input and output terminals shall be shorted respectively.)
(4) AC 60Hz, 1min, 40 to 60%RH.
*4 For 10s
Low Profile Type
Solid State Relays
s Outline Dimensions
(Unit : mm)
23^±0.2
7^±0.2
Common to pin No.2
R3.8^±0.2
φ3.7^{±0.2 6.4±0.2}
Model No.
S108T01
S108T02
S208T01
S208T02
8A 125VAC
8A 265VAC
3^±0.2
Common to pin No.2 ^30°±5_0.5±0.2
1.6^±0.2
Epoxy resin
S108T01
8A125VAC
∼5
+−
Lot No.
(DIN Standard)
3-1.2^±0.2
(3.5)
3-1.4^±0.3
1.8^±0.3
4-0.8^±0.2
12
3
(3.8)
4
(2.54)
0.4^±0.1
(5.08) (10.16)
(1.8)
Internal connection diagram
S108T01/S208T01
S108T02/S208T02
12
34
1 Output (Triac T1)
2 Output (Triac T2)
3 Input (+)
4 Input (−)
12
34
Z.C. : Zero-cross circuit
1 Output (Triac T1)
2 Output (Triac T2)
3 Input (+)
4 Input (−)
5 _{: Do not allow external connection.}
g ( ) : Typical dimensions
Notice In the absence of confirmation by device specification sheets, SHARP takes no responsibility for any defects that may occur in equipment using any SHARP
devices shown in catalogs, data books, etc. Contact SHARP in order to obtain the latest device specification sheets before using any SHARP device.
Internet Internet address for Electronic Components Group http://www.sharp.co.jp/ecg/