S101N11 Datasheet, PDF (1/4 Pages) Sharp Electrionic Components – Voltage Input Type Solid State Relay with Built-in Snubber Circuit

S101N11/S101N12/S201N11/S201N12
S101N11/S101N12
S201N11/S201N12
s Features
1. Built-in snubber circuit
2. Input side voltage operation type
3. Built-in zero-cross circuit (S101N12/S201N12)
4. RMS ON-state current IT : MAX. 1.6Arms
s Applications
1. Programmable controllers
2. Copiers
3. Air conditioners
4. Automatic vending machines
s Model line-ups
For 100V lines
No zero-cross circuit
S101N11
Built-in zero-cross circuit S101N12
For 200V lines
S201N11
S201N12
s Absolute Maximum Ratings
(Ta=25°C)
Parameter
Symbol Rating
Unit
Input
Input signal voltage
Reverse voltage
VIN
VR
3 to 6
6
V
V
S101N11
Standard S101N12
voltage _S201N11
−
S201N12
120
Vrms
240
Operating frequency f
47 to 63
Hz
Output
S101N11
Output
supply ^S101N12 Vout
voltage ^S201N11
S201N12
60 to 140
Vrms
60 to 280
RMS ON-state current IT
*1_1.6
Arms
*2_{Peak one cycle surge current Isurge}
15
A
Operating temperature Topr −25 to +80 °C
Storage temperature Tstg
*3_{Isolation voltage}
Viso
*4_{Soldering temperature Tsol}
−30 to +85
3.0
260
°C
kVrms
°C
*1 Refer to Fig.1
*2 50Hz sine wave, start at Tj=25°C
*3 Isolation voltage measuring method
(1) Dielectric withstand voltage tester with zero cross circuit shall be used.
(2) The applied voltage waveform shall be sine wave.
(3) Voltage shall be applied between input and output.
(Input and output terminals shall be shorted respectively.)
(4) AC 60Hz, 1min, 40 to 60%RH.
*4 For 5s
Voltage Input Type
Solid State Relay
with Built-in Snubber Circuit
s Outline Dimensions
(Unit : mm)
26.0^MAX.
5.5^MAX.
S101N11
INPUT
5VDC
−+
OUTPUT
1.6A120VAC
∼
Lot No.
(DIN Standard)
2.54
2.54 10.16 7.62
0.5
1.3^±0.3
43
2
1
Model No.
S101N11
S101N12
S201N11
S201N12
Internal connection diagram
S101N11/S201N11
S101N12/S201N12
43
2
1
1 Output (Triac T1)
2 Output (Triac T2)
3 Input (+)
4 Input (−)
g Unspecified tolerance : ±0.4mm
43
2
1
Z.C. : Zero-cross circuit
1 Output (Triac T1)
2 Output (Triac T2)
3 Input (+)
4 Input (−)
Notice In the absence of confirmation by device specification sheets, SHARP takes no responsibility for any defects that may occur in equipment using any SHARP
devices shown in catalogs, data books, etc. Contact SHARP in order to obtain the latest device specification sheets before using any SHARP device.
Internet Internet address for Electronic Components Group http://www.sharp.co.jp/ecg/