PC942 Datasheet, PDF (1/8 Pages) Sharp Electrionic Components – High Power Output Type OPIC Photocoupler

PC942
PC942
High Power Output Type
OPIC Photocoupler
s Features
1. Built-in base amplifier for inverter drive
2. High power (IO1 : MAX. 0.5A (DC))
(IO2P : MAX. 2.0A (pulse))
3. High isolation voltage (Viso : 5 000Vrms)
4. High speed response (tPHL,tPLH : MAX. 5µs)
s Applications
1. Inverter controlled air conditioners
2. Small capacitance general purpose inverters
s Absolute Maximum Ratings
(Ta=Topr unless otherwise specified)
Parameter
Symbol Rating
Unit
*1_{Forward current IF}
Input
*2_{Reverse voltage VR}
25
mA
6
V
Supply voltage
VCC
18
V
O1 output current IO1
0.5
A
*3_{O1 peak output current IO1P}
1.0
A
Output O2 output current IO2
0.6
A
*3_{O2 peak output current IO2P}
2.0
A
O1 output voltage VO1
18
V
*4_{Power dissipation PO}
500
mW
*5_{Total power dissipation}
Ptot
550
mW
*6_{Isolation voltage}
Viso
5 000
Vrms
Operating temperature
Storage temperature
Topr −20 to +80 ˚C
Tstg −55 to +125 ˚C
*7_{Soldering temperature}
Tsol
260
˚C
*1 The derating factors of absolute maximum ratings due to ambient temperature are
shown in Fig.8
*2 Ta=25˚C
*3 Pulse width<=5µs, Duty ratio:0.01
*4, 5 The derating factors of absolute maximum ratings due to ambient temperature
are shown in Fig.9
*6 AC for 1min, 40 to 60%RH Ta=25˚C
*7 For 10s
s Outline Dimensions
(Unit : mm)
8765
Internal connection diagram
1.2^±0.3
0.85^±0.2
8 7 6 ^Tr.2 5
PC942
Tr.1
Interface
Anode
mark
1234
9.66^±0.5
Amp
1
23 4
7.62^±0.3
2.54^±0.25
0.5^±0.1
Epoxy resin
0.26^±0.1
θ
θ
θ=0 to 13°
1 Anode
2 Cathode
3 NC
4 NC
5 O₁
6 O₂
7 GND
8 V_CC
* "OPIC" (Optical IC) is a trademark of the SHARP Corporation.
An OPIC consists of a light-detecting element and signal-processing circuit
integrated onto a single chip.
Notice In the absence of confirmation by device specification sheets, SHARP takes no responsibility for any defects that may occur in equipment using any SHARP
devices shown in catalogs, data books, etc. Contact SHARP in order to obtain the latest device specification sheets before using any SHARP device.
Internet Internet address for Electronic Components Group http://www.sharp.co.jp/ecg/