PC935 Datasheet, PDF (1/6 Pages) Sharp Electrionic Components – Digital Output, High Sensitivity Type OPIC Photocoupler

PC930 Series
PC930 Series
Digital Output, High Sensitivity
Type OPIC Photocoupler
s Features
1. High sensitivity
( I_FLH , I _FHL : MAX. 1mA )
2. TTL and LSTTL compatible output
3. Operating supply voltage range
( V_CC : 4.5 to 15V, PC930/PC931/PC932/PC933 )
4. Various output forms
( Open collector output, pull-up resistor
built-in type, totem pole output )
5. Low output current dissipation
( I_CCL : MAX. 3.8mA )
6. High isolation voltage between input and
output ( Viso : 5 000V rms )
7. Recognized by UL, file No. E64380
s Model Line-up
Low active
High active
Open collector
output type
PC930
PC931
Pull-up resistor
built-in type
PC932
PC933
Totem pole
output type
PC934
PC935
s Applications
1. Computer terminals
2. High speed line receivers
3. Interfaces with various data transmission
equipment
s Absolute Maximum Ratings
Parameter
Symbol Rating Unit
Forward current
IF
20
mA
*1_{Peak forward current}
Input
I FM
1
A
Reverse voltage
VR
6
V
Power dissipation
P
70
mW
PC930/PC931
Supply voltage PC932/PC933 V CC
- 0.5 to 16.0
V
PC934/PC935
- 0.5 to 7.0
Output ^{High level output voltage PC930/PC931 V} OH ^{- 0.5 to 16.0 V}
High level output current PC934/PC935 I OH
- 800
µA
Low level output current
I OL
50
mA
Power dissipation
PO
150
mW
Total power dissipation
P tot
170
mW
*2_{Isolation voltage}
V iso
5 000
V rms
Operating temperature
T opr - 25 to + 85 ˚C
Storage temperature
T stg - 40 to + 125 ˚C
*3_{Soldering temperature}
T sol
260
˚C
s Outline Dimensions
654
( Unit : mm)
Model No.
Anode
mark
123
0.9 ^{± 0.2}
1.2 ^±0.3
7.12 ^{± 0.5}
7.62 ^{± 0.3}
0.5 ^{± 0.1}
2.54 ^{± 0.25}
0.26 ^{± 0.1}
θ
θ
θ = 0 to 13 ˚
Internal connection diagram
PC930/PC931
654
PC932/PC933
654
Amp
Amp
123
PC934/PC935
654
123
Voltage
•••••• _regulator
Amp
123
1 Anode
2 Cathode
3 NC
4 V_O
5 GND
6 V_CC
* “ OPIC ” ( Optical IC ) is a trademark of the SHARP Corporation.
An OPIC consists of a light-detecting element and signal-
processing circuit integrated onto a single chip.
*1 Pulse width <=100 µ s
Duty ratio : 0.001
*2 40 to 60% RH,
AC for 1 minute
*3 For 10 seconds
“ In the absence of confirmation by device specification sheets, SHARP takes no responsibility for any defects that occur in equipment using any of SHARP's devices, shown in catalogs,
data books, etc. Contact SHARP in order to obtain the latest version of the device specification sheets before using any SHARP's device. ”