PC922 Datasheet, PDF (1/6 Pages) Sharp Electrionic Components – High Power OPIC Photocoupler

PC922
PC922
High Power OPIC Photocoupler
g Lead forming type ( I type ) and taping reel type ( P type ) are also available. ( PC922I/PC922P)
gg TÜV ( VDE 0884 ) approved type is also available as an option.
s Features
s Outline Dimensions
1. Built-in base amplifier for inverter drive
2. High power ( IO1: MAX. 0.5A ( DC ) )
(I_O2P : MAX. 2.0A ( pulse ) )
3. High isolation voltage between input
and output ( Viso : 5 000V rms )
4. High noise reduction type
5. High speed response ( tPHL , t PLH : MAX. 5 µ s )
6. High sensitivity ( IFLH : MAX. 3mA )
7. Recognized by UL, file No. E64380
1.2 ^{± 0.3}
0.85 ^{± 0.2}
8 7 65
PC922
Anode
mark
123 4
( Unit : mm)
Internal connection diagram
876 5
Tr1
Tr2 Interface
Amp
1 23 4
s Applications
1. Inverter controlled air conditioners
2. Small capacitance general purpose inver-
ters
9.66 ^{± 0.5}
7.62 ^{± 0.3}
0.5 ^{± 0.1}
2.54 ^{± 0.25}
0.26 ^{± 0.1}
θ
θ
θ = 0 to 13 ˚
1 Anode
2 Cachode
3 NC
4 NC
5 O₁
6 O₂
7 GND
8 V_CC
s Absolute Maximum Ratings
Input
Output
Parameter
Forward current
*1_{Reverse voltage}
Supply voltage
O1 output current
*2_{O1 peak output current}
O2 output current
*2_{O2 peak output current}
O1 output voltage
Power dissipation
Total power dissipation
*3 _{Isolation voltage}
Operating temperature
Storage temperature
*4 _{Soldering temperature}
* “ OPIC ” ( Optical IC ) is a trademark of the SHARP Corporation.
An OPIC consists of a light-detecting element and signal-
processing circuit integrated onto a single chip.
( _{Ta = Topr} unless otherwise specified)
Symbol
IF
VR
V CC
IO1
I O1P
IO2
I O2P
V O1
PO
P tot
V iso
T opr
T stg
T sol
Rating
25
6
18
0.5
1.0
0.6
2.0
18
500
550
5 000
- 20 to + 80
- 55 to + 125
260
Unit
mA
V
V
A
A
A
A
V
mW
mW
V rms
˚C
˚C
˚C
*1 Ta = 25˚C
*2 Pulse width <= 5 µ s, Duty ratio : 0.01
*3 40 to 60% RH, AC for 1 minute,
Ta = 25˚C
*4 For 10 seconds
“ In the absence of confirmation by device specification sheets, SHARP takes no responsibility for any defects that occur in equipment using any of SHARP's devices, shown in catalogs,
data books, etc. Contact SHARP in order to obtain the latest version of the device specification sheets before using any SHARP's device. ”