PC400 Datasheet, PDF (1/4 Pages) Sharp Electrionic Components – Compact, Surface Mount Type OPIC Photocoupler

PC400
PC400
Compact, Surface Mount Type
OPIC Photocoupler
s Features
1. Mini-flat package
2. “ Low ” output during light emission
3. Isolation voltage between input and output
( V_iso : 3 750V ) _rms
4. TTL and LSTTL compatible output
5. Recognized by UL(No.E64380)
s Applications
1. Hybrid substrate which requires high den-
sity mounting
2. Personal computers, office computers and
peripheral equipment
3. Electronic musical instruments
s Outline Dimensions
( Unit : mm)
1.27 ^{± 0.25}
654
Internal connection
diagram
Voltage regulator
PC400
6
1
5
Anode mark
3 Amp.
4
2.54 ^{± 0.25}
0.4 ^{± 0.1}
1
3
3.6 ^{± 0.3}
C0.4
(Input Side)
5.3 ^{± 0.3}
0.5
+
-
0.4
0.2
6˚
7.0
+
-
0.2
0.7
1 Anode
2 NC
3 Cathode
4 Vo
5 GND
6 Vcc
s Package Specifications
Model No. Package specifications
PC400 Taping package ( Net:3 000pcs. )
PC400T Taping package ( Net: 750pcs. )
PC400Z Sleeve package ( Net: 100pcs. )
Diameter of reel
φ 370mm
φ 178mm
-
Tape width
12mm
12mm
-
* “ OPIC ” ( Optical IC ) is a trademark of the SHARP Corporation.
An OPIC consists of a light-detecting element and signal-
processing circuit integrated onto a single chip.
s Absolute Maximum Ratings
Input
Output
Parameter
Forward current
Reverse voltage
Power dissipation
Supply voltage
High level output voltege
Low level output current
Power dissipation
Total power dissipation
*1 _{Isolation voltege}
Operating temperature
Storage temperature
*2_{Soldering temperature}
*1 AC for 1 minute, 40 to 60% RH
*2 For 10 seconds
Symbol
IF
VR
P
V CC
V OH
I OL
PO
P tot
V iso
T opr
T stg
T sol
( Ta = 25˚C)
Rating
Unit
50
mA
6
V
70
mW
16
V
16
V
50
mA
130
mW
150
mW
3 750
V rms
- 25 to + 85 ˚C
- 40 to + 125 ˚C
260
˚C
Soldering area
“ In the absence of confirmation by device specification sheets, SHARP takes no responsibility for any defects that occur in equipment using any of SHARP's devices, shown in catalogs,
data books, etc. Contact SHARP in order to obtain the latest version of the device specification sheets before using any SHARP's device.”