|
PC123XNNSZ0F Datasheet, PDF (1/16 Pages) Sharp Electrionic Components – DIP 4pin Reinforced Insulation Type Photocoupler | |||
|
PC123XNNSZ0F Series
PC123XNNSZ0F DIP 4pin Reinforced Insulation Type
Photocoupler
Series
â Description
PC123XNNSZ0F Series contains an IRED optically
coupled to a phototransistor.
It is packaged in a 4-pin DIP, available in wide-lead
spacing option and SMT gullwing lead-form option.
Input-output isolation voltage(rms) is 5kV.
CTR is 50% to 400% at input current of 5mA
â Features
1. 4-pin DIP package
2. Double transfer mold package (Ideal for Flow Solder-
ing)
3. Current transfer ratio (CTR : MIN. 50% at IF=5 mA,
VCE=5V)
4. Several CTR ranks available
5. Reinforced insulation type (Isolation distance : MIN.
0.4mm)
6. Long creepage distance type (wide lead-form type
only : MIN. 8mm)
7. High isolation voltage between input and output
(Viso(rms) : 5kV)
8. Lead-free and RoHS directive compliant
â Agency approvals/Compliance
1. Recognized by UL1577 (Double protection isolation),
ï¬le No. E64380 (as model No. PC123)
2. Approved by BSI, BS-EN60065, file No. 7087, BS-
EN60950 ï¬le No. 7409, (as model No. PC123)
3. Approved by SEMKO, EN60065, EN60950, (as mod-
el No. PC123)
4. Approved by DEMKO, EN60065, EN60950, (as mod-
el No. PC123)
5. Approved by NEMKO, EN60065, EN60950, (as mod-
el No. PC123)
6. Approved by FIMKO, EN60065, EN60950, (as model
No. PC123)
7. Recognized by CSA ï¬le No. CA95323, (as model No.
PC123)
8. Approved by VDE, DIN EN60747-5-2(â) (as an op-
tion), ï¬le No. 40008087 (as model No. PC123)
9. Package resin : UL ï¬ammability grade (94V - 0)
(â) DIN EN60747-5-2 : successor standard of DIN VDE0884.
â Applications
1. I/O isolation for MCUs (Micro Controller Units)
2. Noise suppression in switching circuits
3. Signal transmission between circuits of different po-
tentials and impedances
4. Over voltage detection
Notice The content of data sheet is subject to change without prior notice.
In the absence of conï¬rmation by device speciï¬cation sheets, SHARP takes no responsibility for any defects that may occur in equipment using any SHARP
devices shown in catalogs, data books, etc. Contact SHARP in order to obtain the latest device speciï¬cation sheets before using any SHARP device.
Sheet No.: D2-A09501EN
1
Date Sep. 1. 2006
© SHARP Corporation
|
▷ |