IR3Y48M Datasheet, PDF (1/31 Pages) Sharp Electrionic Components – CCD Signal Process & Digital Interface IC

IR3Y48M
IR3Y48M
CCD Signal Process & Digital Interface IC
DESCRIPTION
The IR3Y48M is a CMOS single-chip signal
processing IC for CCD area sensors which includes
correlated double sampling circuit (CDS), clamp
circuit, automatic gain control amplifier (AGC),
reference voltage generator, black level detection
circuit, 20 MHz 10-bit analog-to-digital converter
(ADC), timing circuit for internally required pulses,
and serial interface for internal circuits.
FEATURES
• Low power consumption :
110 mW (TYP.) at 20 MHz mode
• Wide AGC range : 0 to 36 dB
(Gain step : 0.094 dB/step)
• High speed sample-and-hold circuits :
pulse width 10 ns (MIN.)
• Power save operation :
84 mW (TYP.) at 15 MHz mode
• Standby mode : less than 0.3 mW
• Built-in serial interface
• 10-bit ADC operating up to 20 MHz
– Non-linearity
DNL : 0.6 LSB (TYP.)
INL : 1.5 LSB (TYP.)
• Maximum input level of CCD signals : 1.1 Vp-p
• Accepts a direct signal input to ADC or AGC
(input level : 1 Vp-p (TYP.))
• Single +3 V power supply
• Package :
48-pin QFP (QFP048-P-0707) 0.5 mm pin-pitch
PIN CONNECTIONS
48-PIN QFP
TOP VIEW
48 47 46 45 44 43 42 41 40 39 38 37
NC 1
AVDD4 2
NC 3
VRN 4
VRP 5
AVDD2 6
AVDD2 7
AVSS2 8
AVSS2 9
VCOM 10
CCDIN 11
REFIN 12
36 OP
35 RESETN
34 AVDD3
33 AVSS3
32 STBYN
31 CSN
30 SDATA
29 SCK
28 OBP
27 CCDCLP
26 BLK
25 ADCLP
13 14 15 16 17 18 19 20 21 22 23 24
(QFP048-P-0707)
In the absence of confirmation by device specification sheets, SHARP takes no responsibility for any defects that may occur in equipment using any SHARP devices shown in
catalogs, data books, etc. Contact SHARP in order to obtain the latest device specification sheets before using any SHARP device.
1