GP1A21 Datasheet, PDF (1/4 Pages) Sharp Electrionic Components – OPIC Photointerrupter with Connector

GP1A21
s Features
1. Snap-in mounting type
2. Uses 3-pin connector terminal
3. High sensing accuracy ( Slit width : 0.5mm )
4. Wide gap between light emitter and detec-
tor ( 5mm )
s Applications
1. Copiers
2. Printers
3. Facsimiles
GP1A21
OPIC Photointerrupter with
Connector
s Outline Dimensions
(Unit : mm )
15.5
5.0 5.0 5.0
Internal connection diagram
Voltage regulator
Amp.
1
2
1 GND
2 V_O
3 ^{3 VCC}
6.8
3.4
Slit width
0.5 ^{± 0.1}
g
3
2
1
3.0
4.0
3.4
4.0
2 - 0.9
11.8
15.8 ^{± 0.1}
10.8 ^{± 0.1}
* Unspecified tolerances shall be as follows;
19.8
0.9
22.0
Dimensions(d) Tolerance
d< 5.0 ± 0.15
3.0 ^{± 0.1}
5.0<=d< 15.0 ± 0.2
15.0<=d
± 0.3
* ( ) : Reference dimensions
g MOLEX JAPAN CO., LTD.
made connector 5267-03A
Recommended connectors on
the inserted side
Housing : 5264-03
Terminal : 5263 PBT etc.
*“ OPIC” ( Optical IC ) is a trademark of the SHARP Corporation.
An OPIC consists of a light-detecting element and signal-
processing circuit integrated onto a single chip.
Note ) Terminal No. shown in the above figure is
sometimes different from the number shown
on the connector.
s Absolute Maximum Ratings
(Ta= 25˚C )
Parameter
Supply voltage
*1_{Output voltage}
*2 _{Low level output current}
*3_{Operating temperature}
*3 _{Storage temperature}
Symbol Rating Unit
V CC - 0.5 to + 7 V
VO - 0.5 to + 28 V
I OL
50
mA
Topr - 20 to + 75 ˚C
Tstg - 30 to + 85 ˚C
*1 Collector-emitter voltage of output transistor
*2 Collector current of output transistor
*3 The connector should be plugged in/out and the unit's hook
should be used at normal temperature.
“ In the absence of confirmation by device specification sheets, SHARP takes no responsibility for any defects that occur in equipment using any of SHARP's devices, shown in catalogs,
data books, etc. Contact SHARP in order to obtain the latest version of the device specification sheets before using any SHARP's device.”