6N137 Datasheet, PDF (1/5 Pages) Toshiba Semiconductor – IRED & PHOTO IC (DEGITAL LOGIC ISOLATION, TELE-COMMUNICATION, ANALOG DATA EQUIPMENT CONTROL)

6N137
6N137
Super High Speed Response
OPIC Photocoupler
s Features
1. Super high speed response
( t_PHL , t _PLH : TYP. 45ns at R _L = 350Ω )
2. Isolation voltage between input and output
V iso : 2 500Vrms
3. Low input current drive ( IFHL : MAX. 5mA )
4. Instantaneous common mode rejection
voltage
CM H : TYP. 500V / µ s
5. LSTTL and TTL compatible output
6. Recognized by UL , file No. E64380
s Outline Dimensions
( Unit : mm)
0.85 ^{± 0.3}
1.2
876 5
6N137
Internal connection
diagram
876 5
123
1.2 ^{± 0.3}
4
0.8 ^{± 0.2}
Primary side mark ( Sunken place )
9.22 ^{± 0.5}
123 4
7.62 ^{± 0.3}
s Applications
1. High speed interfaces for computer
peripherals, microcomputer systems
2. High speed line receivers
3. Noise reduction
4. Interfaces for data transmission equipment
s Absolute Maximum Ratings
Input
Output
Parameter
*1 _{Forward current}
*2 _{Peak forward current}
Reverse voltage
Supply voltage
Enable voltage
High level output voltage
Low level output current
Output collector
power dissipation
*5 _{Isolation voltage}
Operating temperature
Storage temperature
*6 _{Soldering temperature}
*1 Ta = 0 to 70 ˚C
*2 Pulse width <= 1ms
*3 For 1 minute MAX.
*4 Not exceed 500mV or more than
supply voltage ( VCC )
0.5 ^{± 0.1}
θ
2.54^{± 0.25}
θ
θ = 0 to 13 ˚
0.26 ^{± 0.1}
1 NC
2 Anode
3 Cathode
4 NC
5 GND
6 VO
7 VE
8 V CC
Symbol
IF
I FM
VR
V CC
CE
V OIL
I OL
* “ OPIC ” ( Optical IC ) is a trademark of the SHARP Corporation.
An OPIC consists of a light-detecting element and signal-
processing circuit integrated onto a single chip.
(Ta = 25˚C)
Rating
Unit
20
mA
40
mA
5
V
7
V
5.5
V
7
V
50
mA
PC
85
mW
V iso
2 500
V rms
T opr
0 to + 70
˚C
T stg
- 55 to + 125
˚C
T sol
260
˚C
*5 AC for 1 minute, 40 to 60% RH
Apply the specific voltage between all the input
electrode pins connected together and all the
output electrode pins connected together.
*6 2mm or more away from the lead base for 10
seconds
“ In the absence of confirmation by device specification sheets, SHARP takes no responsibility for any defects that occur in equipment using any of SHARP's devices, shown in catalogs,
data books, etc. Contact SHARP in order to obtain the latest version of the device specification sheets before using any SHARP's device.”