SGM84782_15 Datasheet, PDF (2/11 Pages) SG Micro Corp – Low Voltage Analog Switch/Multiplexer

SGM84782
4Ω, High Speed, Low Voltage
Analog Switch/Multiplexer
PACKAGE/ORDERING INFORMATION
MODEL
SGM84782
PIN-
PACKAGE
TQFN-3×3-16L
TSSOP-16
SPECIFIED
TEMPERATURE
RANGE
-40℃ to +85℃
-40℃ to +85℃
ORDERING
NUMBER
SGM84782YTQ16/TR
SGM84782YTS/TR
PACKAGE
MARKING
84782
SGM84782YTS
PACKAGE
OPTION
Tape and Reel, 3000
Tape and Reel, 3000
ABSOLUTE MAXIMUM RATINGS
V₊ to GND....................................................................0V to 4.6V
Analog, Digital voltage range....................... -0.3V to (V₊) + 0.3V
Continuous Current NO, NC, or COM ............................±100mA
Operating Temperature Range............................-40℃ to +85℃
Junction Temperature........................................................150℃
Storage Temperature Range..............................-65℃ to +150℃
Lead Temperature (soldering, 10s)....................................260℃
ESD Susceptibility
HBM..................................................................................4000V
MM......................................................................................400V
NOTE: Stresses beyond those listed under “Absolute Maximum
Ratings” may cause permanent damage to the device. These
are stress ratings only, and functional operation of the device at
these or any other conditions beyond those indicated in the
operational sections of the specifications is not implied.
Exposure to absolute maximum rating conditions for extended
periods may affect device reliability.
PIN DESCRIPTION
CAUTION
This integrated circuit can be damaged by ESD if you don’t pay
attention to ESD protection. SGMICRO recommends that all
integrated circuits be handled with appropriate precautions.
Failure to observe proper handling and installation procedures
can cause damage. ESD damage can range from subtle
performance degradation to complete device failure. Precision
integrated circuits may be more susceptible to damage because
very small parametric changes could cause the device not to
meet its published specifications.
SGMICRO reserves the right to make any change in circuit
design, specification or other related things if necessary without
notice at any time. Please contact SGMICRO sales office to get
the latest datasheet.
PIN
TSSOP-16 TQFN-3×3-16L
1, 5, 2, 4
15, 3, 16, 2
3
1
6
4
7
8
9
10
12, 14, 15, 11
13
16
5
6
7
8
10, 12, 13, 9
11
14
—
Exposed Pad
NAME
Y0-Y3
Y
ENABLE
N.C.
GND
B
A
X0-X3
X
V₊
GND
FUNCTION
Analog Switch Y Inputs Y0-Y3.
Analog Switch Y Output.
Digital Enable Input. Normally connect to GND. Drive to logic
high to set all switches off.
Not Internally Connected.
Ground.
Digital Address B Input.
Digital Address A Input.
Analog Switch X Inputs X0-X3.
Analog Switch X Output.
Power Supply.
Exposed pad should be soldered to PCB board and connected
to GND.
2
SG Micro Corp
www.sg-micro.com