SGM5018_15 Datasheet, PDF (2/11 Pages) SG Micro Corp – SPDT Analog Switch

SGM5018
4.5Ω, High Speed, Low Voltage
Quad, SPDT Analog Switch
PACKAGE/ORDERING INFORMATION
MODEL
SGM5018
PIN-PACKAGE
TSSOP-16
SPECIFIED
TEMPERATURE
RANGE
-40℃to +85℃
ORDERING
NUMBER
SGM5018YTS/TR
PACKAGE
MARKING
SGM5018YTS
PACKAGE
OPTION
Tape and Reel, 3000
ABSOLUTE MAXIMUM RATINGS
V+ to GND.................................................................-0.3V to 6V
Analog, Digital voltage range ⁽¹⁾...................-0.3V to (V₊) + 0.3V
Continuous Current NO, NC, or COM ...........................±100mA
Operating Temperature Range...........................-40℃ to +85℃
Junction Temperature...................................................... 150℃
Storage Temperature Range.......................... -65℃ to +150℃
Lead Temperature (soldering, 10s)................................. 260℃
ESD Susceptibility
HBM.................................................................................4000V
MM.....................................................................................400V
NOTES:
1. Signals on NC, NO, or COM or INX exceeding V+ will be clamped by internal diodes. Limit forward diode current to maximum
current ratings.
2. Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress
ratings only, and functional operation of the device at these or any other conditions beyond those indicated in the operational sections
of the specifications is not implied. Exposure to absolute maximum rating conditions for extended periods may affect device reliability.
CAUTION
This integrated circuit can be damaged by ESD if you don’t pay attention to ESD protection. SGMICRO recommends that all
integrated circuits be handled with appropriate precautions. Failure to observe proper handling and installation procedures can cause
damage. ESD damage can range from subtle performance degradation to complete device failure. Precision integrated circuits may
be more susceptible to damage because very small parametric changes could cause the device not to meet its published
specifications.
SGMICRO reserves the right to make any change in circuit design, specification or other related things if necessary without notice at
any time. Please contact SGMICRO sales office to get the latest datasheet.
PIN DESCRIPTION
NAME
V₊
GND
IN
EN
COM_X
NO_X
NC_X
PIN
16
8
1
15
4, 7, 9, 12
3, 6, 10, 13
2, 5, 11, 14
FUNCTION
Power Supply.
Ground.
Digital Control Pin to Connect the COM Terminal to the NO or NC Terminals.
Digital Enable Input. Normally connect to GND. Drive to logic high to set all
switches off.
Common Terminal.
Normally-Open Terminal.
Normally-Closed Terminal.
NOTE: NO_X, NC_X and COM_X terminals may be an input or output.
2
SG Micro Corp
www.sg-micro.com