SGM4717_15 Datasheet, PDF (2/12 Pages) SG Micro Corp – Dual, SPDT Analog Switch

SGM4717
4.5Ω, 300MHz Bandwidth,
Dual, SPDT Analog Switch
PACKAGE/ORDERING INFORMATION
MODEL
SGM4717
PIN-
PACKAGE
WLCSP-2.0×1.5-10B
MSOP-10
SPECIFIED
TEMPERATURE
RANGE
-40℃ to +85℃
-40℃ to +85℃
ORDERING
NUMBER
SGM4717YG/TR
SGM4717YMS/TR
PACKAGE
MARKING
4717YG
SGM4717YMS
PACKAGE
OPTION
Tape and Reel, 3000
Tape and Reel, 3000
ABSOLUTE MAXIMUM RATINGS
V₊, IN to GND.............................................................-0.3V to 6V
Analog, Digital voltage range ⁽¹⁾................... -0.3V to (V+) + 0.3V
Continuous Current NO, NC, or COM..............................±50mA
Peak Current NO, NC, or COM .......................................±80mA
Operating Temperature Range............................-40℃ to +85℃
Junction Temperature........................................................150℃
Storage Temperature Range.............................- 65℃ to +150℃
Lead Temperature (soldering, 10s)....................................260℃
ESD (HBM).......................................................................2000V
NOTES:
1. Signals on NC, NO, or COM or IN exceeding V+ will be clamped by internal diodes. Limit forward diode current to maximum current
ratings.
2. Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress
ratings only, and functional operation of the device at these or any other conditions beyond those indicated in the operational sections
of the specifications is not implied. Exposure to absolute maximum rating conditions for extended periods may affect device reliability.
CAUTION
This integrated circuit can be damaged by ESD if you don’t pay attention to ESD protection. SGMICRO recommends that all
integrated circuits be handled with appropriate precautions. Failure to observe proper handling and installation procedures can cause
damage. ESD damage can range from subtle performance degradation to complete device failure. Precision integrated circuits may
be more susceptible to damage because very small parametric changes could cause the device not to meet its published
specifications.
SGMICRO reserves the right to make any change in circuit design, specification or other related things if necessary without notice at
any time. Please contact SGMICRO sales office to get the latest datasheet.
PIN DESCRIPTION
NAME
V₊
GND
IN1, IN2
COM1, COM2
NO1, NO2
NC1, NC2
FUNCTION
Power Supply.
Ground.
Digital Control Pin to Connect the COM Terminal to the NO or NC Terminals.
Common Terminal.
Normally-Open Terminal.
Normally-Closed Terminal.
NOTE: NO, NC and COM terminals may be an input or output.
SG Micro Corp
2
www.sg-micro.com