SGM4583 Datasheet, PDF (2/17 Pages) SG Micro Corp – CMOS Analog Switch

SGM4583
High Voltage, CMOS Analog Switch
PACKAGE/ORDERING INFORMATION
MODEL
PIN-
PACKAGE
SOIC-16
SGM4583
SSOP-16
TSSOP-16
TQFN-3×3-16L
ORDERING
NUMBER
SGM4583YS16G/TR
SGM4583YQS16G/TR
SGM4583YTS16G/TR
SGM4583YTQ16G/TR
PACKAGE
MARKING
SGM4583YS16
XXXXX
SGM4583
YQS16
XXXXX
SGM4583
YTS16
XXXXX
4583TQ
XXXXX
PACKAGE
OPTION
Tape and Reel, 2500
Tape and Reel, 3000
Tape and Reel, 3000
Tape and Reel, 3000
NOTE: XXXXX = Date Code and Vendor Code.
ABSOLUTE MAXIMUM RATINGS
Voltages Referenced to V_EE
VCC......................................................................-0.3V to 13.2V
GND……………………………………………...……. -0.3V to 6V
Voltage into Any Terminal ⁽¹⁾
………………………………………(V_EE - 0.3V) to (V_CC + 0.3V)
Continuous Current into Any Terminal.............................±20mA
Peak Current, X_, Y_, Z_
(pulsed at 1ms, 10% duty cycle) ......................................±40mA
Operating Temperature Range............................-40℃ to +85℃
Junction Temperature........................................................150℃
Storage Temperature Range..............................-65℃ to +150℃
Lead Temperature (Soldering, 10s)...................................260℃
ESD Susceptibility
HBM..................................................................................3000V
MM..................................................................................... 150V
NOTES:
1. Voltages exceeding VCC or VEE on any signal terminal are
clamped by internal diodes. Limit forward-diode current to
maximum current rating.
2. Stresses beyond those listed under “Absolute Maximum
Ratings” may cause permanent damage to the device. These
are stress ratings only, and functional operation of the device at
these or any other conditions beyond those indicated in the
operational sections of the specifications is not implied.
Exposure to absolute maximum rating conditions for extended
periods may affect device reliability.
CAUTION
This integrated circuit can be damaged by ESD if you don’t pay
attention to ESD protection. SGMICRO recommends that all
integrated circuits be handled with appropriate precautions.
Failure to observe proper handling and installation procedures
can cause damage. ESD damage can range from subtle
performance degradation to complete device failure. Precision
integrated circuits may be more susceptible to damage because
very small parametric changes could cause the device not to
meet its published specifications.
SGMICRO reserves the right to make any change in circuit
design, specification or other related things if necessary without
notice at any time. Please contact SGMICRO sales office to get
the latest datasheet.
SG Micro Corp
2
www.sg-micro.com