SGM3157_15 Datasheet, PDF (2/11 Pages) SG Micro Corp – Low Voltage SPDT Analog Switch in 6-Pin SC70

SGM3157
4.5Ω Low Voltage SPDT
Analog Switch in 6-pin SC70
PACKAGE/ORDERING INFORMATION
MODEL
SGM3157
PIN-
PACKAGE
SC70-6
SPECIFIED
TEMPERATURE
RANGE
-40℃ to +85℃
ORDERING
NUMBER
SGM3157YC6/TR
PACKAGE
MARKING
3157
PACKAGE
OPTION
Tape and Reel, 3000
ABSOLUTE MAXIMUM RATINGS
V+, IN to GND.............................................................-0.3V to 6V
Analog, Digital voltage range ⁽¹⁾................... -0.3V to (V₊) + 0.3V
Continuous Current NO, NC, or COM..............................±50mA
Peak Current NO, NC, or COM .......................................±80mA
Operating Temperature Range........................... -40℃ to +85℃
Junction Temperature........................................................150℃
Storage Temperature Range.......................... -65℃ to +150℃
Lead Temperature (soldering, 10s)................................ 260℃
ESD (HBM).................................................................... 2000V
ESD (MM)........................................................................ 400V
NOTES:
1. Signals on NC, NO, or COM or IN exceeding V₊ will be clamped by internal diodes. Limit forward diode current to maximum current
ratings.
2. Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress
ratings only, and functional operation of the device at these or any other conditions beyond those indicated in the operational sections
of the specifications is not implied. Exposure to absolute maximum rating conditions for extended periods may affect device reliability.
CAUTION
This integrated circuit can be damaged by ESD if you don’t pay attention to ESD protection. SGMICRO recommends that all
integrated circuits be handled with appropriate precautions. Failure to observe proper handling and installation procedures can cause
damage. ESD damage can range from subtle performance degradation to complete device failure. Precision integrated circuits may
be more susceptible to damage because very small parametric changes could cause the device not to meet its published
specifications.
SGMICRO reserves the right to make any change in circuit design, specification or other related things if necessary without notice at
any time. Please contact SGMICRO sales office to get the latest datasheet.
PIN DESCRIPTION
NAME
NO
GND
NC
COM
V₊
IN
PIN
FUNCTION
1
Normally-Open Terminal.
2
Ground.
3
Normally-Closed Terminal.
4
Common Terminal.
5
Power Supply.
6
Digital Control Pin to Connect the COM Terminal to the NO or NC Terminals.
NOTE: NO, NC and COM terminals may be an input or output.
SG Micro Corp
2
www.sg-micro.com