ZBXYA025M0 Datasheet, PDF (4/5 Pages) Sensortechnics GmbH – Oxygen sensor interface boards

ZBXYA
Oxygen sensor interface boards
OUTLINE DRAWING & ELECTRICAL CONNECTION (cont.)
ZBXYA...M...
Dimensions:
63 x 108 mm,
Ø 4 mm mounting holes
Connector:
15 pin male D connector
Operating and Calibration Notes for ZBXYA...M
1. Reset of the ZBXYA...M interface board is possible by putting the power off/on.
2. A proper operation of a connected sensor and electronic circuit can be tested with the test switch or with an external
signal. After switching the test function the output signal should indicate a 20% lower value.
3. LED indication: proper sensor operation is indicated by blinking of LED D3.
4. Calibration: sensor and circuit can be calibrated in normal air. After a loss of power the ZBXYA...M circuit stores the
calibration value.
May 2008 / 638
4/5
www.sensortechnics.com