DSDXL005D4D Datasheet, PDF (1/6 Pages) Sensortechnics GmbH – Digital pressure transducers

DSDXL Series
Digital pressure transducers
FEATURES
GENERAL DESCRIPTION
· 0...±5, 0...±10, 0...10 "H₂O
differential/gage
· Digital readout via I²C-bus
· Precision ASIC conditioning
· Temperature compensated
· Non-ratiometric output
APPLICATIONS
· Medical instrumentation
· HVAC controls
· Pneumatic controls
The DSDXL series offers a digital
interface on a very cost-effective basis.
This family is fully calibrated and
temperature compensated using an
on-board ASIC. These sensors are
intended for use with non-corrosive,
non-ionic working fluids such as air
and dry gases.
The DSDXL010D4R device is
available to measure gage pressure
from 0...10 "H O.
2
The DSDXL...4D devices are available
to measure differential pressures from
0...±5 "H₂O (DSDXL005D4D) to
0...±10 "H₂O (DSDXL010D4D).
Differential devices allow application
of pressure to either side of the
sensing diaphragm and can be used
for gage or differential measurements.
All DSDXL devices are accurate to
within ±2.5 %FSS. The devices are
characterized for operation from a
single 5 V supply. The sensor is
designed and manufactured
according to standards laid down in
ISO 9001.
ELECTRICAL CONNECTION
+Vs
N/C
6
1
5
DSDXL 7
2
84 3
SCL
SDA
IC
220 nF
15 nF
N/C
GND
Note: A capacitor of 220 nF is required
between +Vs and GND.
Pin 2 is an internal device connection and
should be connected to ground with a
15 nF capacitor.
It is important to place the capacitors as
close to the pins as possible!
Pins 4, 6 and 8 are internal device
connections and should not be
connected for any reason!
July 2007 / 588
1/6
www.sensortechnics.com