GBU6005 Datasheet, PDF (1/2 Pages) Diodes Incorporated – 6.0A GLASS PASSIVATED BRIDGE RECTIFIER

GBU6005 THRU GBU610
GLASS PASSIVATED SINGLE-PHASE BRIDGE RECTIFIERS
Reverse Voltage – 50 to 1000 Volts
Forward Current – 6.0 Amperes
Features
• Plastic material has Underwriters Laboratory
Flammability Classification 94V-0
• Ideal for printed circuit boards
• Glass passivated chip junction
• Reliable low cost construction utilizing molded
plastic technique
Mechanical Data
• Case: Molded plastic GBU
• Terminals: leads solderable per MIL-STD-202
Method 208 guaranteed
• Mounting Position: Any
Absolute Maximum Ratings and Characteristics
Rating at 25℃ ambient temperature unless otherwise specified. Single-phase, half wave, 60Hz, resistive or inductive
load. For capacitive load, derate current by 20%.
GBU GBU GBU GBU GBU GBU GBU
Symbols
Units
6005 601 602 604 606 608 610
Maximum recurrent peak reverse voltage
Maximum RMS voltage
Maximum DC blocking voltage
Maximum average forward rectified current
at TC = 100℃ (Note 1)， (Note 2)
VRRM
VRMS
VDC
50 100 200 400 600 800 1000 V
35 70 140 280 420 560 700 V
50 100 200 400 600 800 1000 V
IF(AV)
6
A
Peak forward surge current，8.3ms single half-sine-wave
superimposed on rated load (JEDEC Method)
IFSM
175
A
Maximum forward voltage
at 3.0A DC and 25℃
VF
1
V
Maximum reverse current at TA = 25℃
at rated DC blocking voltage TA = 125℃
IR
5
µA
500
Typical junction capacitance (Note 3)
CJ
211
94
pF
Typical thermal resistance (Note 1),(Note 2)
R_θJA
7.4
℃/W
Typical thermal resistance (Note 1),(Note 2)
Operating and storage temperature range
R_θJC
TJ ,TS
2.2
-55 to +150
℃/W
℃
Notes: (1). Units case mounted on 2.6x1.4x0.06” thick (6.5x3.5x0.15 cm) AI. plate heatsink..
(2). Recommended mounting position is to bolt down on heatsink with silicone thermal compound for maximum
heat transfer with #6 screws.
(3). Measured at 1MHz and applied reverse voltage of 4.0 VDC.
SEMTECH ELECTRONICS LTD.
(Subsidiary of Semtech International Holdings Limited, a company
listed on the Hong Kong Stock Exchange, Stock Code: 724)
R
Dated : 16/02/2004