XE8802 Datasheet, PDF (99/193 Pages) Semtech Corporation – Sensing Machine Data Acquisition MCU

XE8802 Sensing Machine Data Acquisition MCU
with ZoomingADC™ and LCD driver
15.1 Features
The USRT implements a hardware support for software implemented serial protocols:
ƒ Control of two external lines S0 and S1 (read/write).
ƒ Conditional edge detection generates interrupts.
ƒ S0 rising edge detection.
ƒ S1 value is stored on S0 rising edge.
ƒ S0 signal can be forced to 0 after a falling edge on S0 for clock stretching in the low state.
ƒ S0 signal can be stretched in the low state after a falling edge on S0 and after a S1 conditional detection.
15.2 Overview
The USRT block supports software universal synchronous receiver and transmitter mode interfaces.
External lines S0 and S1 respectively correspond to clock line and data line. S0 is mapped to PB[4] and S1 to
PB[5] when the USRT block is enabled. It is independent of RegPBdir (Port B can be input or output). When
USRT is enabled, the configurations in port B for PB[4] and PB[5] are overwritten by the USRT configuration.
Internal pull-ups can be used by setting the PBPullup[5:4] bits.
Conditional edge detections are provided.
RegUsrtS1 can be used to read the S1 data line from PB[5] in receive mode or to drive the output S1 line PB[5] by
writing it when in transmit mode. It is advised to read S1 data when in receive mode from the RegUsrtBufferS1
register, which is the S1 value sampled on a rising edge of S0.
15.3 Register map
Register name
RegUsrtS1
RegUsrtS0
RegUsrtCtrl
RegUsrtCond1
RegUsrtCond2
RegUsrtBufferS1
RegUsrtEdgeS0
Table 15-1: USRT registers
Block configuration registers:
pos.
7-1
0
RegUsrtS1
“0000000”
UsrtS1
rw
reset
function
r-
Unused
r/w 1 nresetglobal Write: data S1 written to pad PB[5]),
Read: value on PB[5] (not UsrtS1 value).
Table 15-2: RegUsrtS1
© Semtech 2006
15-2
www.semtech.com