SH3001 Datasheet, PDF (3/20 Pages) Semtech Corporation – Real-Time Clock and Clock Management Support IC for Microcontrollers

SH3001 MicroBuddy™
SYSTEM MANAGEMENT
Pin Descriptions
Pin Name
Type
Function
1
VSS
Power Ground, 0 V. All VSS pins and TEST (VSS) pin must be connected together.
Output of internal Voltage Regulator, 2.2 V nominal. This pin can power external loads
2
VREG
Power of <5 mA. If load is “noisy” it requires a bypass capacitor. May be left unconnected or
used as a high logic level signal for CLKSEL pin (see below).
3
VDD
Power Main power supply, +2.3 to +5.5 V.
Backup power supply for real-time clock, +2.3 to +5.5 V (+1.8 to +5.5 V typical). This
4
VBAK
Power voltage can be higher or lower than VDD. Connect a backup battery or backup
capacitor (with external recharge circuit). Connect to VDD if not used.
5
XIN
Analog In Oscillator pins for optional external low frequency crystal, typically 32.768 kHz crystal
6 XOUT Analog Out with nominal 12.5 pF load capacitance. Keep open or connect to VSS if not used.
7 CLKSEL Digital In Must be tied to VREG
8
VSS
Power Ground, 0 V. All VSS pins and TEST (VSS) pin must be connected together.
9
NC
Not connected - reserved
10 NC
Not connected - reserved
11 NC
Not connected - reserved
12 TEST (VSS) Digital In Factory test enable. All VSS pins and TEST (VSS) pin must be connected together.
Buffered internal 32.768 kHz clock, derived according to the CLKSEL pin setting. This pin
uses backup power for the buffer when VDD is not present. When driving high, this signal
13
CLK32
Digital Out
is either at VBAK or VDD (if VDD is higher than the reset threshold). When enabled, this
signal runs continuously independent of CLKOUT activity. Minimize the external load to
reduce power consumption during backup operations. When disabled, this pin is driven
to VSS. Keep open if not used.
Serial communications interface and interrupt output pin. This pin is internally weakly
14 IO/INT
I/O
pulled to the opposite of the programmed interrupt polarity. For example, if interrupt is
programmed to be active low, this pin is weakly pulled to VDD when inactive. Keep
open if not used.
Clock activity sense input. Used to detect when the target microcontroller enters stop
15 CLKIN Digital In mode (which disables its clock). Connect to the microcontroller’s clock output or
oscillator output pin. Connect to VSS when not used. CLKIN must not be left open.
16
CLKOUT
Digital Out
Programmable high frequency clock output. Connect to the target microcontroller’s clock
input or oscillator input pin. Keep open if not used.
Copyright ©2002-2005 Semtech Corporation
3
V1.15 www.semtech.com