EZ1580 Datasheet, PDF (2/5 Pages) Semtech Corporation – DUAL INPUT LOW DROPOUT REGULATOR

February 26, 1999
PIN CONFIGURATION
DUAL INPUT
LOW DROPOUT REGULATOR
EZ1580/EZ1581
EZ1582/EZ1583
PIN DESCRIPTION
Pin Pin Name
Pin Function
1 SENSE This pin is the positive side of the reference voltage for this device. With this pin it is possible to
Kelvin sense the output voltage at the load.
2 ADJUST / This pin is the negative side of the reference voltage for the device. Transient response can be
improved by adding a small bypass capacitor from the adjust pin to ground.
GROUND This pin is the bottom end of the internal resistor feedback chain for fixed output voltage parts,
and should be connected to ground.
3 OUTPUT This is the power output of the device, and is electrically connected to the TAB.
4 CONTROL This pin is the supply pin for the control circuitry for the device. The current flow into this pin will
be approximately 1% of the output current. For the device to regulate, the voltage at this pin must
be between 1.0V and 1.3V greater than the output voltage (see dropout specifications).
5 POWER This is the collector input to the power device of the EZ158X. The output load current is supplied
through this pin. For the device to regulate, the voltage on this pin must be between 0.1V and
0.7V greater than the output voltage, depending upon load current (see dropout specifications).
© 1999 SEMTECH CORP.
2
652 MITCHELL ROAD NEWBURY PARK CA 91320