TS33001 Datasheet, PDF (1/16 Pages) List of Unclassifed Manufacturers – High Efficiency Synchronous 1A/2A DC/DC Buck Converter, 5Mhz

TRIUNE PRODUCTS
Features
• Fixed Output option has automatic low power PFM mode
for reduced quiescent current at light loads
• 5MHz +/- 10% fixed switching frequency
• Fixed output voltages: 0.8V, 0.9V, 1.2V, 1.5V, 1.8V,
• 2.5V, and 3.3V with +/- 2% output tolerance
• Input voltage range: 2.5V to 5.5V
• Voltage mode PWM control with input voltage feed-
• Forward compensation
• Voltage supervisor for VOUT reported at the PG pin
• Input supply under voltage lockout
• Soft start for controlled startup with no overshoot
• Full protection for over-current, over-temperature,
• and VOUT overvoltage
• Less than 200nA in shutdown mode
• Multiple enable pins for flexible system sequencing
• Low external component count
• Junction operating temperature -40C to 125C
• Packaged in a 16 pin QFN (3x3)
Applications
• Point of load
• Systems with deep submicron ASICs/FPGAs
• Set-top box
• Communications equipment
• Portable and handheld equipment
TS33001/2/3
High Efficiency Synchronous 1/2/3A
DC/DC Buck Converter, 5Mhz
Description
The TS33001/2/3 (1/2/3A) are DC/DC synchronous switching
regulators with fully integrated power switches, internal
compensation, and full fault protection. The switching
frequency of 5MHz enables the use of extremely small filter
components, resulting in smaller board space and reduced
BOM costs.
When the input current is greater than approximately 50mA,
the TS33001/2/3 utilizes PWM voltage mode feedback with input
voltage feed-forward to provide a wide input voltage range
without the need for external compensation.
When the input current is less than 50mA, the device uses a
PFM mode to provide increased efficiency at light loads. The
cross over between PFM mode and PWM is automatic and
has hysteresis to prevent oscillation between the modes.
Additionally, the nLP mode pin can be used to force the device
into PWM mode to reduce the output ripple, if needed.
The TS33001/2/3 integrates a wide range of protection circuitry;
including input supply under-voltage lockout, output under-
voltage, output over-voltage, soft start, high side FET and low side
FET current limits, and thermal shutdown.
Typical Applications
VCC
nLP
EN
Fixed Output
VCC
1µH
VSW
22uF
VOUT
Sense
FB
nLP
EN
PG
VOUT
10uF
VCC or VOUT
10 kohm
(optional)
PG
TS33001/2/3
Final Datasheet Rev 1.6
January 15, 2016
www.semtech.com
1 of 16
Semtech
Proprietary & Confidential