|
SC810_1 Datasheet, PDF (1/20 Pages) Semtech Corporation – Single Input/Single Mode Single-cell Li-ion Charger | |||
|
SC810
POWER MANAGEMENT
Features
 Input voltage protection â 30V
 Single input charger
 Constant voltage â 4.2V, 1% regulation
 Charging by current and voltage regulation (CC/CV)
 Thermal limiting of charge current
 Programmable fast-charge current
 Current-limited adapter support â reduces power dis-
sipation in charger IC
 Instantaneous CC-to-CV transition for faster charging
 Three termination options â float-charge, automatic
re-charge, or forced re-charge to keep the battery
topped-off after termination without float-charging
 Soft-start reduces adapter load transients
 High operating voltage range permits use of unregu-
lated adapters
 Complies with CCSA YD/T 1591-2006
 Space saving 2Ã2Ã0.6 (mm) MLPD package
 Pb free, Halogen free, and RoHS/WEEE compliant
Applications
 Mobile phones
 MP3 players
 GPS handheld receivers
Single Input/Single Mode
Single-cell Li-ion Charger
Description
The SC810 is a linear single-cell Li-ion battery charger in a
6 lead 2Ã2mm MLPD Ultra-thin package. The input will
survive sustained input voltage up to 30V to protect
against hot plug overshoot and faulty charging adapters.
Charging begins automatically when a valid input source
is applied. Thermal limiting protects the SC810 from
excessive power dissipation. It can be programmed to
turn off when charging is complete or to continue operat-
ing as an LDO regulator while float-charging the battery.
The input will charge with an adapter operating in voltage
regulation or in current-limit to obtain the lowest possible
power dissipation by pulling the input voltage down to
the battery voltage. The maximum fast-charge current
setting is 1A.
Charge current is programmed with a single resistor. Pre-
charge and termination current are fixed at 20% and 10%,
respectively, of the programmed fast-charge current.
Charge current steps up to the programmed value (soft
starts) to reduce load transients on the charging adapter.
Typical Application Circuit
VADAPTER
2.2 μF
SC810
VIN
STATB
GND
ENB
BAT
IPRGM
2.2 μF
Device
Load
Battery
Pack
September 17, 2009
© 2009 Semtech Corporation
1
|
▷ |