|
SC810 Datasheet, PDF (1/19 Pages) Semtech Corporation – Single Input/Single Mode Single-cell Li-ion Charger | |||
|
POWER MANAGEMENT
Features
 Single input charger
 Constant voltage â 4.2V, 1% regulation
 Fast-charge current regulation â 15% at 70mA,
9% at 700mA
 Three mode charging â current regulation, voltage
regulation, and thermal limiting
 Input voltage protection â 30V
 Current-limited charging support â reduces power
dissipation in charger IC
 Instantaneous CC-to-CV transition for faster charging
 Three termination options â float-charge, automatic
re-charge, or forced re-charge to keep the battery
topped-off after termination without float-charging
 Soft-start reduces adapter load transients
 High operating voltage range permits use of
unregulated adapters
 Complies with CCSA YD/T 1591-2006
 Space saving 2x2x0.6 (mm) MLPD package
 WEEE and RoHS compliant
Applications
 Mobile phones
 MP3 players
 GPS handheld receivers
SC810
Single Input/Single Mode
Single-cell Li-ion Charger
Description
The SC810 is a linear single-cell Li-ion battery charger in a
6 lead 2x2 MLPD Ultra-thin package. The input will survive
sustained input voltage up to 30V to protect against hot
plug overshoot and faulty charging adapters.
Charging begins automatically when a valid input source
is applied. Thermal limiting protects the SC810 from
excessive power dissipation. It can be programmed to
turn off when charging is complete or to continue operat-
ing as an LDO regulator while float-charging the battery.
The input will charge with an adapter operating in voltage
regulation or in current-limit to obtain the lowest possible
power dissipation by pulling the input voltage down to
the battery voltage. The maximum fast-charge current
setting is 1A.
Charge current is programmed with a single resistor. Pre-
charge and termination current are fixed at 20% and 10%,
respectively, of the programmed fast-charge current.
Charge current steps up to the programmed value (soft
starts) to reduce load transients on the charging adapter.
Typical Application Circuit
VADAPTER
2.2 μF
SC810
VIN
STATB
GND
ENB
BAT
IPRGM
2.2 μF
Device
Load
Battery
Pack
February 26, 2008
© 2008 Semtech Corporation
1
|
▷ |