RCLAMP0522P Datasheet, PDF (1/13 Pages) Semtech Corporation – Ultra Low Capacitance TVS Arrays

PROTECCTTIIOONN PPRROODDUUCCTTSS- RailClamp^
Description
RailClamps are ultra low capacitance TVS arrays
designed to protect high speed data interfaces. This
series has been specifically designed to protect sensitive
components which are connected to high-speed data
and transmission lines from overvoltage caused by ESD
(electrostatic discharge), CDE (Cable Discharge Events),
and EFT (electrical fast transients).
The RClamp^TM0522P and RClamp^TM0524P have a
typical capacitance of only 0.30pF between I/O pins.
This allows it to be used on circuits operating in excess
of 3GHz without signal attenuation. They may be used to
meet the ESD immunity requirements of IEC 61000-4-2,
Level 4 (±15kV air, ±8kV contact discharge). The
RClamp0522P is designed to protect two lines, while the
RClamp0524P will protect four lines.
The RClamp0522P is in a 6-pin, RoHS/WEEE compliant,
SLP1610P4 package. It measures 1.6 x 1.0 x 0.58mm.
The RClamp0524P is in a 10-pin, RoHS/WEEE compliant,
SLP2510P8 package. It measures 2.5 x 1.0 x 0.58mm.
The leads are spaced at a pitch of 0.5mm and are finished
with lead-free NiPd. They are designed for easy PCB layout
by allowing the traces to run straight through the device.
The combination of small size, low capacitance, and high
level of ESD protection makes them a flexible solution for
applications such as HDMI, UDI, DisplayPort^TM, MDDI, Serial
ATA, and Infiniband circuits.
Circuit Diagram - RClamp0522P
RClamp0522P
RClamp0524P
Ultra Low Capacitance TVS Arrays
PRELIMINARY
Features
ESD protection for high-speed data lines to
IEC 61000-4-2 (ESD) ±15kV (air), ±8kV (contact)
IEC 61000-4-5 (Lightning) 5A (8/20µs)
IEC 61000-4-4 (EFT) 40A (5/50ns)
Package design optimized for high speed lines
Flow-Through design
Protects two or four I/O lines
Low capacitance: 0.3pF typical (I/O to I/O)
Low clamping voltage
Low operating voltage: 5V
Solid-state silicon-avalanche technology
Mechanical Characteristics
SLP1610P4 6-pin package (1.6 x 1.0 x 0.58mm)
SLP2510P8 10-pin package (2.5 x 1.0 x 0.58mm)
RoHS/WEEE Compliant
Lead Pitch: 0.5mm
Lead finish: NiPd
Marking: Marking Code
Packaging: Tape and Reel per EIA 481
Applications
High Definition Multi-Media Interface (HDMI)
Digital Visual Interface (DVI)
Unified Display Interface (UDI)
DisplayPort^TM Interface
MDDI Ports
PCI Express
Serial ATA
Circuit Diagram - RClamp0524P
Pin 1
Pin 2
3, 4
2-Line Protection
Revision 09/19/2006
Pin 1
Pin 2
Pin 4
Pin 5
3, 8
4-Line Protection
1
www.semtech.com