English
Language : 

SR40200 Datasheet, PDF (1/2 Pages) SeCoS Halbleitertechnologie GmbH – 40.0 AMP Schottky Barrier Rectifiers
Elektronische Bauelemente
SR40200
VOLTAGE 200V
40.0 AMP Schottky Barrier Rectifiers
RoHS Compliant Product
A suffix of "-C" specifies halogen & lead-free
ƔFEATURES
. Low forward voltage drop
. High current capability
. High reliability
. High surge current capability
. Epitaxial construction
ƔMECHANICAL DATA
. Case: Molded plastic
. Epoxy: UL 94V-0 rate flame retardant
. Lead: Lead solderable per MIL-S TD-202,
method 208 guaranteed
. Polarity: As Marked
. Mounting position: Any
. Weight: 5.60 grams
TO-247 (TO-3P)
.144(3.65)
.128(3.25) DIA.
.244(6.20)
.228(5.8)
.638(16.20)
.605(15.38)
.319(8.10)
.303(7.69)
.881(22.38)
.812(20.63)
.177(4.50)
.122(3.1)
.110(2.8)
.153(3.90)
.204(5.20)
.181(4.60)
30
.846(21.50)
.728(18.50)
.050(1.30)
.045(1.10)
.223(5.66)
.207(5.26)
PIN 1
PIN 3
+
CAS E
PIN 2
Dimens ions in inches and (millimeters )
.095
(2.4)
.027(0.70)
.019(0.48)
ƔMAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS
Rating 25 к ambient temperature unless otherwise specified.
Single phase half wave, 60Hz, resistive or inductive load.
For capacitive load, derate current by 20%.
TYPE NUMBER
SR40200
Maximum Recurrent Peak Reverse Voltage
200
Working Peak Reverse Voltage
200
Maximum DC Blocking Voltage
200
Maximum Average Forward Rectified Current,
See Fig. 1
40.0
Peak Forward Surge Current, 8.3 ms single half Sine-wave
superimposed on rated load (JEDEC method)
350
Maximum Instantaneous Forward Voltage at 20.0A
0.92
Maximum DC Reverse Current Ta=25 к!
0.03
At Rated DC Blocking Voltage Ta=125 к!
4.5
Typical Junction Capacitance (Note 1)
900
Typical Thermal Resistance RșJC (Note 2)
3.0
Operating Temperature Range TJ
-50 ~ +150
Storage Temperature Range TSTG
-65 ~ +175
NOTES:
1. Measured at 1MHz and applied reverse voltage of 5.0V D.C.
2. Thermal Resistance Junction to Ambient Vertical PC Board Mounting 0.5"(12.7mm) Lead Length.
UNITS
V
V
V
A
A
V
µA
pF
к/W
к
к
http://www.SeCoSGmbH.com/
01-Jun-2002 Rev. A
Any changing of specification will not be informed individual
Page 1 of 2