SMAJ Datasheet, PDF (1/4 Pages) Jinan Gude Electronic Device – SURFACE MOUNT TRANSIENT VOLTAGE SUPPRESSOR

SMAJ SERIES
Elektronische Bauelemente
VOLTAGE 5.0V ~ 170V
400W Peak Power Surface Mount TVS
RoHS Compliant Product
A suffix of "-C" specifies halogen & lead-free
FEATURES
* For surface mount application
* Built-in strain relief
* Excellent clamping capability
* Low profile package
* Fast response time: Typically less than
1.0ps from 0 volt to BV min.
* Typical IR less than 1mA above 10V
* High temperature soldering guaranteed:
260 C / 10 seconds at terminals
MECHANICAL DATA
A
B
D
G
F
* Case: Molded plastic
* Epoxy: UL 94V-0 rate flame retardant
* Lead: Solderable per MIL-STD-202,
method 208 guaranteed
* Polarity: Color band denotes cathode end except Bidirectional
* Mounting position: Any
* Weight: 0.063 grams
Dimensions in Dimensions in
C
Millimeters
Inches
A 1.25 1.65 0.049 0.065
B 3.99 4.60 0.157 0.181
H
C 2.50 2.90 0.098 0.114
D 1.98 2.44 0.078 0.096
E 0.051 0.203 0.002 0.008
F 4.78 5.28 0.188 0.208
E
G 0.76 1.52 0.030 0.060
H 0.006 0.012 0.305 0.152
MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS
Rating 25 C ambient temperature unless otherwise specified.
Single phase half wave, 60Hz, resistive or inductive load.
For capacitive load, derate current by 20%.
RATINGS
Peak Power Dissipation at TA=25 C, TP=1ms(NOTE 1)
Peak Forward Surge Current at 8.3ms Single Half Sine-Wave
superimposed on rated load (JEDEC method) (NOTE 3)
Maximum Instantenous Forward Voltage at 25.0A for
Unidirectional only
Operating and Storage Temperature Range
SYMBOL
PPK
IFSM
VF
TJ, TSTG
NOTES:
1. Non-repetitive current pulse per Fig. 3 and derated above TA=25 C per Fig. 2.
2. Mounted on Copper Pad area of 5.0mm²(.013mm Thick) to each terminal.
3. 8.3ms single half sine-wave, duty cycle = 4 pulses per minute maximum.
VALUE
Minimum 400
40
3.5
-55 to +150
UNITS
Watts
Amps
Volts
C
DEVICES FOR BIPOLAR APPLICATIONS
1. For Bidirectional use C or CA Suffix for types SMAJ5.0 thru SMAJ170.
2. Electrical characteristics apply in both directions.
http://www.SeCoSGmbH.com
01-Jun-2006 Rev. B
Any changing of specification will not be informed individual
Page 1 of 4