|
SH236 Datasheet, PDF (1/6 Pages) SeCoS Halbleitertechnologie GmbH – Hall Effect Latch Sink Driver IC | |||
|
Elektronische Bauelemente
SH236
Complementary Output
Hall Effect Latch Sink Driver IC
RoHS Compliant Product
Description
The SH236 is an integrated Hall effect latched sensor with
output pull-high resistor driver designed for electronic co-
mmutation of brushless DC motor applications. The device
includes an on-chip Hall voltage generator for magnetic
sensing, a comparator that amplifies the Hall voltage, and a
Schmitt trigger to provide switching hysteresis for noise re-
jection, and complementary open-collector drivers for sinking
large current loads. An internal bandgap regulator is used to
provide temperature compensated supply voltage for internal
circuits and allows a wide operating supply range. If a magnetic
flux density larger than threshold Bop, DO is turned on (low)
and DOB is turned off (high). The output state is held until a
magnetic flux density reversal falls below Brp causing DO to be
turned off and DOB turned on.SH236 is rated for operation over
temperature range from -20oC to 85oC and voltage range from
3.5V to 20V. The devices are available in low cost die forms or
rugged 4 pin SIP packages.
Features
* High Output Sinking Capability Up To 200mA For Driving Large Load
* Build In Protection Diode For Chip Reverse Power Connecting
* On-Chip Hall Sensor IC With Two Different Sensitivity And
Hysteresis Settings For SH236
* Lower Current Change Rate Reduces The Peak Output Voltage
During Switching
* Internal Bandgap Regulator Allows Temperature Compensated
Operations And A Wide Operating Voltage Range
* Package : SIP-4L
Applications
* Brushless DC Motor
* Speed Measurement
* Revolution Counting
* Brushless DC Fan
REF.
A
A1
b
b1
Millimeter
Min. Max.
1.295 1.803
0.610
0.330 0.432
0.406 0.508
REF.
D
E
L
e
Millimeter
Min. Max.
5.105
5.359
3.531
3.785
14
16
1.27REF
Pin Descriptions
http://www.SeCoSGmbH.com/
01-Jun-2002 Rev. A
Name
Vcc
DO
DOB
Vss
P/I/O
P
O
O
P
Pin# Description
1 Positive Power supply
2 Output Pin
3 Output Pin
4 Ground
Any changing of specification will not be informed individual
Page 1 of 6
|
▷ |