SS5682_1311 Datasheet, PDF (2/8 Pages) SEC Electronics Inc. – Unipolar Hall Switch

SS5682
Unipolar Hall Switch
General Description
The SS5682 is a unipolar Hall effect sensor IC fabri-
cated from mixed signal CMOS technology. The de-
vice integrates a voltage regulator, Hall sensor with
dynamic offset cancellation system, Schmitt trigger
and an open-drain output driver, all in a single pack-
age.
It incorporates advanced chopper stabilization tech-
niques to provide accurate and stable magnetic switch
points. There are many applications for this HED –
Hall Electronic Device - in addition to those listed
above. Thanks to its wide operating voltage range and
extended choice of temperature range, it is quite suita-
ble for use in automotive, industrial and consumer ap-
plications.
The device is delivered in a Small Outline Transistor
(SOT) for surface mount process or in a Plastic Single
In Line (SIP flat) for through- hole mount. Both 3-lead
packages are RoHS compliant.
Glossary of Terms
MilliTesla (mT), Gauss Units of magnetic flux density: 1mT = 10 Gauss
RoHS
Restriction of Hazardous Substances
SOT
Small Outline Transistor (SOT package) – also referred with the package code “SO”
ESD
Electro-Static Discharge
BLDC
Brush-Less Direct-Current
Operating Point (B_OP) Magnetic flux density applied on the branded side of the package which turns the output
driver ON (V_OUT = V_DSon)
Release Point (B_RP) Magnetic flux density applied on the branded side of the package which turns the output
driver OFF (V_OUT = high)
2
V3.10 Nov 1, 2013