10700481 Datasheet, PDF (5/5 Pages) Schurter Inc. – TOUCHSCREEN

7. Durability test:
7.1 Finger touches
Touch panel is hit 10 millions times with a silicone rubber of R8 finger, hitting rate is by 250g at 2 times per
second. The measurement must satisfy the following:
- Circuit close resistance: as Sec. 3.3
- Circuit open resistance: as Sec. 3.4
- Contact bounce: as Sec. 3.5
- Linearity test: as Sec. 3.6
7.2 Stylus writing
Touch panel is drawn by R0.8 Derlin stylus pen, at 250g forces, repeat one inch by 100K times.
The measurement must satisfy the following:
- Circuit close resistance: as Sec. 3.3
- Circuit open resistance: as Sec. 3.4
- Contact bounce: as Sec. 3.5
- Linearity test: as Sec. 3.6
8. Optical Performance
8.1 Optical inspection method and optical defect standards refer to document. A001-2 Touch Screen Optical Quality
Standard.
8.2 Outside to Viewing Area : any optical defected in this area need to be ignored if no effected to touch screen
function.
8.3 Silver Bus Pattern defect : Voids in traces to be less than 50% of the trace width.
8.3.1 Silver Bus Pattern gap: >0.1mm
8.3.2 Silver Bus and Active area gap: No silver ink may project beyond the viewing area.
8.4 Glass defects such as edge chips and scratches refer to A001-2, Touch Screen Optical Quality Standard.
9. Others
9.1 Always store the touch screen in its original shipping container under normal conditions
(20~25°C, 65% RH)
9.2 RoHS, this part is RoHS compliant
Zu Änd. Datum Name
Changes that contribute to technical improvement are subject to alternations
2007 Datum Name
Bearb.
Gepr.
Vert.
28.03.
28.03.
Maurer
Maurer
TOUCHSCREEN
19,0“, 8-Wire
AMT-09548-01
EDV-Datasheet
SPECIFICATIONS OF ANALOG RESISTIVE
PET-ON-GLASS TOUCH SCREEN
don’t change manually
Manufactured by Apex Material Technology Corp.
D 79346 Endingen
H 1070.0481
page 5 of 5 Index: -