10700465 Datasheet, PDF (5/5 Pages) Schurter Inc. – TOUCHSCREEN

7. Durability test:
7.1 Finger touches
Touch panel is hit 10 millions times with a silicone rubber of R8 finger, hitting rate is by 250g at 2 times per
second. The measurement must satisfy the following:
- Circuit close resistance: as Sec. 3.3
- Circuit open resistance: as Sec. 3.4
- Contact bounce: as Sec. 3.5
- Linearity test: as Sec. 3.6
7.2 Stylus writing
Touch panel is drawn by R0.8 Derlin stylus pen, at 250g forces, repeat one inch by 100K times.
The measurement must satisfy the following:
- Circuit close resistance: as Sec. 3.3
- Circuit open resistance: as Sec. 3.4
- Contact bounce: as Sec. 3.5
- Linearity test: as Sec. 3.6
8. Optical Performance
8.1 Optical inspection method and optical defect standards refer to document. A001-2 Touch Screen Optical Quality
Standard.
8.2 Outside to Viewing Area : any optical defected in this area need to be ignored if no effected to touch screen
function.
8.3 Silver Bus Pattern defect : Voids in traces to be less than 50% of the trace width.
8.3.1 Silver Bus Pattern gap: >0.1mm
8.3.2 Silver Bus and Active area gap: No silver ink may project beyond the viewing area.
8.4 Glass defects such as edge chips and scratches refer to A001-2, Touch Screen Optical Quality Standard.
8.5 Others
Always store the touch screen in its original shipping container under normal conditions
(20~25°C, 65% RH)
Zu Änd. Datum Name
Changes that contribute to technical improvement are subject to alternations
2006 Datum Name
Bearb.
Gepr.
Vert.
18.08.
18.08.
Maurer
Maurer
TOUCHSCREEN
19,1“, 8-Wire
AMT-09540-01
EDV-Datasheet
SPECIFICATIONS OF ANALOG RESISTIVE
PET-ON-GLASS TOUCH SCREEN
don’t change manually
Manufactured by Apex Material Technology Corp.
D 79346 Endingen
H 1070.0465
page 5 of 5 Index: -