10700451 Datasheet, PDF (4/4 Pages) Schurter Inc. – TOUCH SCREEN

7. Durability test:
7.1 Finger touches
Touch panel is hit 10 millions times with a silicone rubber of R8 finger, hitting rate is by 250g at 2 times per second.
The measurement must satisfy the following:
- Circuit close resistance: as Sec. 3.3
- Circuit open resistance: as Sec. 3.4
- Contact bounce: as Sec. 3.5
- Linearity test: as Sec. 3.6
7.2 Stylus writing
Touch panel is drawn by R 0,8 Derlin stylus pen, at 250g forces, repeat one inch by 100K times. The measurement
must satisfy the following:
- Circuit close resistance: as Sec. 3.3
- Circuit open resistance: as Sec. 3.4
- Contact bounce: as Sec. 3.5
- Linearity test: as Sec. 3.6
8. Optical Performance
8.1 Optical inspection method and optical defect standards refer to document. A001-1
Touch Screen Optical Quality Standard.
8.2 Outside to Viewing Area : any optical defected in this area need to be ignored if no effected to touch screen function.
8.3 Silver Bus Pattern defect : Voids in traces to be less than 50% of the trace width.
8.3.1 Silver Bus Pattern gap: >0.1mm
8.3.2 Silver Bus and Active area gap: No silver ink may project beyond the viewing area.
8.4 Glass defects such as edge chips and scratches refer to A001-1 Touch Screen Optical Quality Standard.
8.5 Others
8.5.1 Folding line should be avoided on the pressure sensitive adhesive.
8.5.2 Refer to document A001-1 Touch Screen Optical Quality Standard.
8.5.3 Always store the touch screen in its original shipping container under normal conditions
(20~25°C, 65% RH)
to chg.. date
name
Changes that contribute to technical improvement are subject to alternations
2006 Datum Name
Bearb.
Gepr.
Vert.
21.08.
21.08.
Maurer
Maurer
TOUCH SCREEN
6.54“, 4 Wire
AMT -09531-01
EDV-Datasheet
SPECIFICATIONS OF ANALOG RESISTIVE
PET-ON-GLASS TOUCH SCREEN
don’t change manually
Manufactured by Apex Material Technology Corp.
D 79346 Endingen
H 1070,0451
page 4 of 4 Index: -