LB11867RV Datasheet, PDF (6/9 Pages) Sanyo Semicon Device – Variable Speed Single-phase Full-wave Pre-driver

LB11867RV
*6. RMI pin
Minimum speed setting pin.
Perform pull-up with 5VREG when this pin is not to be used.
If the IC power supply is likely to be turned OFF first when the pin is used with external power supply, be sure to
insert the current limiting resistor to prevent inflow of large current. (The same applies to the VTH pin.)
*7. VTH pin
Speed control pin.
Connect this pin to GND when it is not used (at full speed).
For the control method, refer to the timing chart.
For control with pulse input, insert the current limiting resistor and use the pin with the frequency of 20k to 100kHz
(20kHz to 50kHz recommended).
*8. SENSE pin
Current limiting detection pin.
When the pin voltage exceeds 0.2V, the current is limited and the operation enters the lower regeneration mode.
Connect this pin to GND when it is not to be used.
*9. RD pin
Lock detection pin
In open collector output, L upon rotation and H when locked (using pull-up resistance).
Keep this pin open when it is not to be used.
*10. CT pin
Pin to connect the lock detection capacitor.
The constant-current charge and discharge circuits incorporated cause locking when the pin voltage becomes 3.0V
and unlocking when it is 1.1V.
Connect the pin to GND when it is not to be used (locking not necessary).
*11. S-S pin
Pin to connect the soft-start setting capacitor.
Connect the capacitor between 5VREG and S-S pin.
This pin enables setting of the soft start time according to the capacity of the capacitor.
See the timing char.
Connect the pin to GND when it is not to be used.
No.A1534-6/9