LC87F72C8A Datasheet, PDF (4/24 Pages) Sanyo Semicon Device – 8-Bit Single Chip Microcontroller with 128 KB Flash Memory and 2048-Byte RAM On Chip

LC87F72C8A
(17) Standby function
- HALT mode
HALT mode is used to reduce power consumption. During the HALT mode, program execution is stopped but
peripheral circuits keep operating (some parts of serial transfer operation stop.)
1) Oscillation circuits are not stopped automatically.
2) Released by the system reset or interrupts.
-HOLD mode
HOLD mode is used to reduce power consumption. Program execution and peripheral circuits are stopped.
1) CF, RC and crystal oscillation circuits stop automatically.
2) Released by any of the following conditions.
1. Low level input to the reset pin
2. Specified level input to one of INT0, INT1, INT2
3. Port 0 interrupt
-X’tal HOLD made
X’tal HOLD mode is used to reduce power consumption. Program execution is stopped.
All peripheral circuits except the base timer are stopped.
1) CF and RC oscillation circuits stop automatically.
2) Crystal oscillator operation is kept in its state at HOLD mode inception.
3) Released by any of the following conditions
1. Low level input to the reset pin
2. Specified level input to one of INT0, INT1, INT2
3. Port 0 interrupt
4. Base-timer interrupt
(18) Package
- QIP100E
- SQFP100
(19) Development tools
- Evaluation chip: LC876096
- Emulator: EVA62S + ECB876500 (Evaluation chip board) + SUB877200 + POD100QFP or POD100SQFP (Type B)
(20) Same package and pin assignment as mask ROM version.
1) LC877200 series options can be set using flash ROM data. Thus the board used for mass production can
be used for debugging and evaluation without modifications.
2) If the program for the mask ROM version is used, the usable ROM/RAM capacity is the same as the mask
ROM version.
No.6712-4/24