LC876596B Datasheet, PDF (4/23 Pages) Sanyo Semicon Device – 8-Bit Single Chip Microcontroller with 96/80 KB ROM and 2048-Byte RAM On Chip

LC876596B/80B
-X’tal HOLD made
X’tal HOLD mode is used to reduce power consumption. Program execution is stopped.
All peripheral circuits except the base timer are stopped.
1) CF and RC oscillation circuits stop automatically.
2) Crystal oscillator is maintained in its state at HOLD mode inception.
3) Release occurs on any an any of the following conditions
(1) input to the reset pin goes low
(2) a specified level is input to at least one of INT0, INT1, INT2
(3) an interrupt condition arises at port 0
(4) an interrupt condition arises at the base-timer
(18) Factory shipment
-delivery form QIP100E
(19) Development tools
- Evaluation chip: LC876096
- Emulator: EVA62S + ECB876500 (Evaluation chip board) + SUB876500 + POD100QFP
- Flash ROM version: LC87F65C8A
No.6717-4/23