English
Language : 

LC87F7J32A Datasheet, PDF (27/29 Pages) Sanyo Semicon Device – FROM 32K byte, RAM 1024 byte on-chip 8-bit 1-chip Microcontroller
LC87F7J32A
VDD
SW : ON/OFF (programmable)
RLCD
RLCD
RLCD
RLCD
RLCD
RLCD
RLCD
RLCD
RLCD
RLCD
SW: ON (VLCD=VDD)
VLCD
2/3VLCD
1/2VLCD
1/3VLCD
GND
Figure 8 LCD Bias Resistors
(a)
(b)
POR release voltage
(PORRL)
VDD
Unknown-state
(POUKS)
Reset period
100μs or longer
Reset period
RES
Figure 9 Waveform observed when only POR is used (LVD not used)
(RESET pin: Pull-up resistor RRES only)
• The POR function generates a reset only when power is turned on starting at the VSS level.
• No stable reset will be generated if power is turned on again when the power level does not go down to the VSS level
as shown in (a). If such a case is anticipated, use the LVD function together with the POR function or implement an
external reset circuit.
• A reset is generated only when the power level goes down to the VSS level as shown in (b) and power is turned on
again after this condition continues for 100μs or longer.
No.A0886-27/29