LV23411V Datasheet, PDF (23/23 Pages) Sanyo Semicon Device – For Home Stereo Systems FM/AM Tuner IC

Application Circuit Example
LV23411V
I²C_Bus
C10
0.1μF
L2
L1 C9
39nH 39nH 22μF
R2
R3
BPF
4.7kΩ
open
X1
R1
32.768Hz
4.7kΩ
30 29 28 27 26 25 24 23 22 21 20 19 18 17 16
LV23411V
T1
L3
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
For AM Loop antenna
AM CAP
AM ref
AM ANT
GND
LO1
For AM Ferrite antenna
C1
0.1μF
C2
C3
C4 C5
C6
C7 C8
1μF
1μF 1μF 1μF
0.047μF
0.1μF 22μF
MPX IN_OUT
GND
VCC=5V:short
VCC=9V:open
SD
Lout Rout
ST
VCC=5V(9V)
SANYO Semiconductor Co.,Ltd. assumes no responsibility for equipment failures that result from using
products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition
ranges, or other parameters) listed in products specifications of any and all SANYO Semiconductor Co.,Ltd.
products described or contained herein.
SANYO Semiconductor Co.,Ltd. strives to supply high-quality high-reliability products, however, any and all
semiconductor products fail or malfunction with some probability. It is possible that these probabilistic failures or
malfunction could give rise to accidents or events that could endanger human lives, trouble that could give rise
to smoke or fire, or accidents that could cause damage to other property. When designing equipment, adopt
safety measures so that these kinds of accidents or events cannot occur. Such measures include but are not
limited to protective circuits and error prevention circuits for safe design, redundant design, and structural
design.
In the event that any or all SANYO Semiconductor Co.,Ltd. products described or contained herein are
controlled under any of applicable local export control laws and regulations, such products may require the
export license from the authorities concerned in accordance with the above law.
No part of this publication may be reproduced or transmitted in any form or by any means, electronic or
mechanical, including photocopying and recording, or any information storage or retrieval system, or otherwise,
without the prior written consent of SANYO Semiconductor Co.,Ltd.
Any and all information described or contained herein are subject to change without notice due to
product/technology improvement, etc. When designing equipment, refer to the "Delivery Specification" for the
SANYO Semiconductor Co.,Ltd. product that you intend to use.
Upon using the technical information or products described herein, neither warranty nor license shall be granted
with regard to intellectual property rights or any other rights of SANYO Semiconductor Co.,Ltd. or any third
party. SANYO Semiconductor Co.,Ltd. shall not be liable for any claim or suits with regard to a third party's
intellctual property rights which has resulted from the use of the technical information and products mentioned
above.
This catalog provides information as of October, 2011. Specifications and information herein are subject
to change without notice.
PS No.A1990-23/23