LC863G64A Datasheet, PDF (16/21 Pages) Sanyo Semicon Device – CGROM16K-byte on-chip 768-byte RAM and 352×9 bit OSD RAM 8-bit 1-chip Microcontroller

LC863G64A/56A/48A/40A/32A/28A/24A
Sample Current Dissipation Characteristics at Ta = -10°C to +70°C, VSS = 0V
The sample current dissipation characteristics is the measurement result of Sanyo provided evaluation board when the
recommended circuit parameters shown in the sample oscillation circuit characteristics are used externally.
The currents through the output transistors and the pull-up MOS transistors are ignored.
Parameter
Current dissipation
during basic
operation
(Note 4)
Symbol
IDDOP(1)
Pins
VDD
Conditions
•FmX’tal=32.768kHz X’tal oscillation
•System clock: VCO
•VCO for OSD operating
•Internal RC oscillation stops
VDD[V]
Limits
min
typ
max unit
4.5 to 5.5
10
24 mA
IDDOP(2)
•FmX’tal=32.768kHz X’tal oscillation
•System clock: X'tal
(Instruction cycle time: 366.2µs)
•VCO for system, VCO for OSD,
Internal RC oscillation stop
•Data slicer, AD converters stop
4.5 to 5.5
55
300 µA
Current dissipation
in HALT mode
(Note 4)
IDDHALT(1)
•HALT mode
•FmX’tal=32.768kHz X’tal oscillation
•System clock: VCO
•VCO for OSD stops
• Internal RC oscillation stops
4.5 to 5.5
3
9 mA
IDDHALT(2)
IDDHALT(3)
•HALT mode
•FmX’tal=32.768kHz X’tal oscillation
•VCO for system stops
•VCO for OSD stops
•System clock: Internal RC
•HALT mode
•FmX’tal=32.768kHz X’tal oscillation
•VCO for system stops
•VCO for OSD stops
•System clock: X’tal
(Instruction cycle time: 366.2µs)
4.5 to 5.5
4.5 to 5.5
300 1000
µA
45
200
Current dissipation IDDHOLD
•HOLD mode
in HOLD mode
•All oscillation stops.
4.5 to 5.5
0.05
(Note 4)
Note 4: The currents through the output transistors and the pull-up MOS transistors are ignored.
20 µA
No.A0548-16/21