LV8411GR_12 Datasheet, PDF (1/7 Pages) Sanyo Semicon Device – For DSC, and Cell Phone Camera Modules 4-channel Single-chip Motor Driver IC

Ordering number : ENA1250A
LV8411GR
Bi-CMOS LSI
For DSC, and Cell Phone Camera Modules
4-channel Single-chip Motor Driver IC
Overview
The LV8411GR is an H bridge motor driver IC and is able to control 4 modes of forward, reverse, brake, and standby.
This IC housed in a miniature package is optimum for use in a stepping motor driving system for DSC or a camera module
of cell phones.
Features
• Saturation drive H bridge: 4 channels
• Built-in thermal protection circuit
• Built-in low voltage malfunction prevention circuit
• Incorporates a transistor for driving photosensors
Specifications
Absolute Maximum Ratings at Ta = 25°C
Parameter
Symbol
Conditions
Ratings
Unit
Power supply voltage 1
Power supply voltage 2
Output peak current
Output continuous current 1
Output continuous current 2
Allowable power dissipation
VM max
VCC max
IO peak
IO max1
IO max2
Pd max
Channels 1 to 4, t ≤ 10msec, ON-duty ≤ 20%
Channels 1 to 4
PI1
Mounted on a circuit board*
6.0
V
6.0
V
600
mA
400
mA
30
mA
1.05
W
Operating temperature
Topr
-40 to +85
°C
Storage temperature
Tstg
-55 to +150
°C
* Specified circuit board : 40mm×50mm×0.8mm : glass epoxy four-layer board
Caution 1) Absolute maximum ratings represent the value which cannot be exceeded for any length of time.
Caution 2) Even when the device is used within the range of absolute maximum ratings, as a result of continuous usage under high temperature, high current, high
voltage, or drastic temperature change, the reliability of the IC may be degraded. Please contact us for the further details.
Any and all SANYO Semiconductor Co.,Ltd. products described or contained herein are, with regard to
"standard application", intended for the use as general electronics equipment. The products mentioned herein
shall not be intended for use for any "special application" (medical equipment whose purpose is to sustain life,
aerospace instrument, nuclear control device, burning appliances, transportation machine, traffic signal system,
safety equipment etc.) that shall require extremely high level of reliability and can directly threaten human lives
in case of failure or malfunction of the product or may cause harm to human bodies, nor shall they grant any
guarantee thereof. If you should intend to use our products for new introduction or other application different
from current conditions on the usage of automotive device, communication device, office equipment, industrial
equipment etc. , please consult with us about usage condition (temperature, operation time etc.) prior to the
intended use. If there is no consultation or inquiry before the intended use, our customer shall be solely
responsible for the use.
Specifications of any and all SANYO Semiconductor Co.,Ltd. products described or contained herein stipulate
the performance, characteristics, and functions of the described products in the independent state, and are not
guarantees of the performance, characteristics, and functions of the described products as mounted in the
customer's products or equipment. To verify symptoms and states that cannot be evaluated in an independent
device, the customer should always evaluate and test devices mounted in the customer's products or
equipment.
62012 SY 20120604-S00001/70908 MS PC 20080703-S00001 No.A1250-1/7