LV8011V Datasheet, PDF (1/7 Pages) Sanyo Semicon Device – Forward/Reverse Motor Driver

Ordering number : ENN*7230
LV8011V
Bi-CMOS IC
Forward/Reverse Motor Driver
Overview
LV8011V is a 1ch forward/reverse motor driver IC using D-MOS FET for output stage. As MOS circuit is used, it
supports the PWM input. Its features are that the on resistance (0.37Ω typ) and current dissipation are low.
It also provides protection functions such as heat protection circuit and reduced voltage detection and is optimal for the
motors that need high-current (maximum peak current : 5A).
Absolute Maximum Ratings at Ta = 25°C, SGND = PGND = 0V
Parameter
Symbol
Conditions
Maximum Power Source Voltage
(For load)
Maximum Power Source Voltage
(For control)
Maximum Output Current
Input Voltage
Operating Temperature
VM max
VCC max
IO max
IO peak1
IO peak2
VIN max
Topr
DC
t≤100ms, f = 2Hz
t≤10ms, f = 2Hz
Storage Temperature
Tstg
Allowable Power Dissipation
Pd
*Specified substrate
* When mounting the glass epoxy substrate 30mm×50mm×1.6mm.
Ratings
Unit
-0.5 to 7.5
V
-0.5 to 6.0
V
1.0
A
3.0
A
5.0
A
-0.5 to VCC+0.5
V
-20 to +75
°C
-55 to 150
°C
800
mW
Allowable Operating Range at SGND = PGND = 0V
Parameter
Symbol
Power Source Voltage (For load)
VM
Power Source Voltage (For control)
Input Signal Voltage
Input Signal Frequency
VCC
VIN
f max
duty = 50%
Charge-Pump Capacitor
C1, C2, C3
Conditions
Ratings
Unit
2.0 to 6.5
V
4.5 to 5.5
V
0 to VCC
V
100
kHz
0.001 to 0.1
µF
Any and all SANYO Semiconductor products described or contained herein do not have specifications
that can handle applications that require extremely high levels of reliability, such as life-support systems,
aircraft's control systems, or other applications whose failure can be reasonably expected to result in
serious physical and/or material damage. Consult with your SANYO Semiconductor representative
nearest you before using any SANYO Semiconductor products described or contained herein in such
applications.
SANYO Semiconductor assumes no responsibility for equipment failures that result from using products
at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition
ranges, or other parameters) listed in products specifications of any and all SANYO Semiconductor
products described or contained herein.
92706 / 91004 JO IM No.7230-1/7